Abstract:This article presents an 18 similar to 30 GHz vector-sum phase shifter for wireless application in the millimeter-wave regime. It is composed of an I/Q signal generator, two variable-gain amplifiers (VGA), and a digital-to-analog converter with a quadrant selector. To attain wideband quadrature signal, a two-stage hybrid based on transformers is proposed to realize the I/Q signal generator. The first- and second-stage hybrids are designed with different resonating frequencies. As a result, the amplitude and phase errors of the I/Q signal generator are significantly decreased in a wide frequency band. In addition, theoretical analysis based on a simplified equivalent-circuit model is performed to guide the circuit implementation, and its correctness is demonstrated by electromagnetic simulation. To mitigate the impact of the VGAs' parasitics on the phase performance, a capacitive-neutralization technique is applied to cancel parasitics of transistors in the VGAs. A prototype circuit is designed using a 130-nm SiGe BiCMOS process. The measured results show that the circuit achieves a root-mean-square (RMS) amplitude error of less than 1.4 dB and an RMS phase error of 1.4 degrees similar to 3.4 degrees across 18 similar to 32 GHz. The tested peak gains of all the phase states are -1 similar to 4.5 dB with an input balun (approximate to 1.9 dB loss) and an output balun (approximate to 2 dB loss) at 22 GHz. Also, the input 1-dB compression point and noise figure are tested, which are >=-1 dBm and <= 15.5 dB in the targeting frequency band.

A 0.65V 1.2mw 2.4ghz/400mhz Dual-Mode Phase Modulator for Mobile Healthcare Applications

Optimal Design of a Low-Power, Phase-Switching Modulator for Implantable Medical Applications.

An Ultra Broadband Passive Vector Modulator Phase Shifter

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

Low Power High-Speed CMOS Dual-Modulus Prescaler Design with Imbalanced Phase-Switching Technique

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

A 0.8 V Low Power Low Phase-Noise Pll

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

Sub-mW Multi-Ghz CMOS Dual-Modulus Prescalers Based on Programmable Injection-Locked Frequency Dividers

A 2 GHz 2 Mb/s Semi-Digital $2^{+}$-Point Modulator with Separate FIR-Embedded 1-Bit DCO Modulation in 0.18 $\mu$ M CMOS

A Hybrid Loop Two-Point Modulator Without DCO Nonlinearity Calibration by Utilizing 1 Bit High-Pass Modulation

A 2 GHz 2 Mb/s Semi-Digital <formula Formulatype="inline"><tex Notation="TeX">$2^{+}$</tex></formula>-Point Modulator with Separate FIR-Embedded 1-Bit DCO Modulation in 0.18 <formula Formulatype="inline"><tex Notation="TeX">$\mu$</tex> </formula>m CMOS

A 1mb/s 2.86% EVM GFSK Modulator Based on ΔΣ BB-DPLL Without Background Digital Calibration

A 100Mb/s 3.5GHz Fully-Balanced BFOOK Modulator Based on Integer-N Hyrbrid PLL

High-speed Silicon Modulators for the 2 Μm Wavelength Band

Single Chip Silicon Single Sideband Modulator with High Sideband Suppression Ratio

0.6mW 6.3 GHz 40nm CMOS divide‐by‐2/3 prescaler using heterodyne phase‐locking technique

20-Mb/s Gfsk Modulator Based on 3.6-Ghz Hybrid Pll with 3-B Dco Nonlinearity Calibration and Independent Delay Mismatch Control

A Multi-Bit Fir Filtering Technique for Two-Point Modulators with Dedicated Digital High-Pass Modulation Path