Abstract:This paper presents advancements in the performance of digital phase-locked loop (DPLL)s, with a special focus on addressing the issue of required gain calibration in the time-to-digital converter (TDC) within phase-domain DPLL structures. Phase-domain DPLLs are preferred for their simplicity in implementation and for eliminating the delta–sigma modulator (DSM) noise inherent in conventional fractional-N designs. However, this advantage is countered by the critical need to calibrate the gain of the TDC. The previously proposed dual-interpolated TDC(DI-TDC) was proposed as a solution to this problem, but strong spurs were still generated due to the TDC resolution, which easily became non-uniform due to PVT variation, degrading performance. To overcome these problems, this work proposes a DPLL with a new calibration system that ensures consistent TDC resolution matching the period of the digitally controlled oscillator (DCO) and operating in both the foreground and background, thereby maintaining consistent performance despite PVT variations. This study proposes a DPLL using a calibrated dual-interpolated TDC that effectively compensates for PVT variations and improves the stability and performance of the DPLL. The PLL was fabricated in a 28-nm CMOS process with an active area of only 0.019 mm2, achieving an integrated phase noise (IPN) performance of −17.5 dBc, integrated from 10 kHz to 10 MHz at a PLL output of 570 MHz and −20.5 dBc at 1.1 GHz. This PLL operates within an output frequency range of 475 MHz to 1.1 GHz. Under typical operating conditions, it consumes only 930 μW with a 1.0 V supply.

An Overview of Digital-Intensive ΔΣ Phase-Locked Loops Utilizing 1-Bit Conversion and Modulation.

A Phase Lookahead DTC for Fast Settling Switched Loop DPLL

A ΔΣ DPLL with 1b TDC, 4b DTC and 8-tap FIR filter for low-voltage clock generation/modulation systems

A Fully Synthesizable Fractional-N Digital Phase-Locked Loop with a Calibrated Dual-Referenced Interpolating Time-to-Digital Converter to Compensate for Process–Voltage–Temperature Variations

A Digital Optical Phase-Locked Loop For Diode Lasers Based On Field Programmable Gate Array

A Hybrid Loop Two-Point Modulator Without DCO Nonlinearity Calibration by Utilizing 1 Bit High-Pass Modulation

A 2.5GHz ADPLL with PVT-insensitive ΔΣ dithered time-to-digital conversion by utilizing an ADDLL.

A Digital-Intensive F/Pll-Based Two-Point Modulator with A Constant-Gain Dco for Linear Fmcw Generation

Digital LDO with 1-Bit ΔΣ Modulation for Low-Voltage Clock Generation Systems

A Digital Optical Phase-Locked Loop Based on Field Programmable Gate Array and Its Applications

A 5.4 GHZ All-Digital Phase-Locked Loop with a wide output swing and high-linearity DAC

An All‐digital Phase‐locked‐loop with a Robustness Enhanced Dual‐mode DCO

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

Design and Analysis of DTC-Free ΔΣ Bang-Bang Phase-Locked Loops.

A 2.5ghz Adpll With Pvt-Insensitive Delta Sigma Dithered Time-To-Digital Conversion By Utilizing An Addll

15.1 A 0.0066mm2 780μw Fully Synthesizable PLL with a Current-Output DAC and an Interpolative Phase-Coupled Oscillator Using Edge-Injection Technique

A 1mb/s 2.86% EVM GFSK Modulator Based on ΔΣ BB-DPLL Without Background Digital Calibration

A Spread-Spectrum Clock Generator with FIR-embedded Binary Phase Detection and 1-Bit High-Order ΔΣ Modulation.

A 1.5GHz all-digital frequency-locked loop with 1-bit ΔΣ frequency detection in 0.18μm CMOS

Semidigital PLL Design for Low-Cost Low-Power Clock Generation

Hybrid Phase Modulators with Enhanced Linearity