Abstract:Scan based built-in self-test (BIST), which naturally extends scan-based test methodology with test patterns applied from test equipment to BIST, can be used for the self test of sequential circuits and attain higher fault coverage. If the circuit under test (CUT) contains multiple parallel scan chains, a parallel generator is needed. Known as the common pseudo-random pattern generator (PRPG), an LFSR can be configured to generate a random pattern stream. The PRPG-based patterns may be applied to the existing scan architecture directly from the LFSR, or through some decorrelation logic. In order to attain higher fault coverage, it is very important to analyze the test pattern generation in the scan based BIST. The paper presents a kind of scheme for test pattern generation in the scan based BIST for the circuits with multiple scan chains. In the test pattern generation scheme the PRPG, which is implemented by an LFSR, shifts the sequences into all scan chains simultaneously. The correlativity weight R(M) of multiple scan chains is also defined in the paper. Based on the analysis of the different degree effect on fault coverage due to the different configuration of multiple scan chains, one conclusion is drawn that the probability that the fault coverage is reduced is increased with an increase of the correlativity weight R(M). If the circuit is tested by the multiple scan chains with the minimum R(M), the probability that the fault coverage is reduced is least. In the paper a method to construct multiple scan chains with minimum correlativity weight R(M) is proposed to overcome the bad effect on fault coverage due to the correlation between scan chains. Furthermore the minimum set of deterministic patterns is generated for hard-to-test faults by ATPG and the set is used to design the bit modifying logic circuit (BML), which is located between multiple scan chains and the CUT. Through BML the signals in multiple scan chains are controlled to input to the CUT. When the test control signal is low, the test patterns in multiple scan chains are input into the CUT directly. When the test control signal is high, the value of the signals at certain bit positions in the multiple scan chains are modified by BML and the changed test patterns are input into the CUT to test hard-to-test faults for complete fault coverage. The experiments on some ISCAS'89 benchmark circuits show that the complete fault coverage can be obtained by the test method presented by the paper. The overhead of BML is also analyzed.

Self-heating Burn-in Pattern Generation Based on the Genetic Algorithm Incorporated with a BACK-like Procedure.

A test pattern selection method of dynamic burn-in for logic circuits

A genetic algorithm based method for the uniformity of power in SoC during dynamic burn-in

A Test Pattern Selection Method for Dynamic Burn-In of Logic Circuits Based on Atpg Technique

Power-and thermal-aware mapping for NoC under latency constraint

Test pattern generation for static burn-in based on equivalent fault model

A Test Pattern Selection Method for Static Burn-In of ICs

Optimization Algorithm of Evolutionary Design of Circuits Based on Genetic Algorithm

Design Time Body Bias Selection for Parametric Yield Improvement.

Thermal management of integrated circuits in burn-in environment

A Generation Method for Test Patterns with Low Power and Low Cost

A Low Power Test Pattern Generation Method

Data-Driven Prediction of Sintering Burn-Through Point Based on Novel Genetic Programming

Test Pattern Generation in Built-In Self-Test with Multiple Scan Chains

Low-power Weighted Random Pattern Testing

CA optimization based on simulation annealing in BIST

Burn-in Method Study of Surface Mounted Plastic Encapsulated Devices and Board-Level Verification

An Device Case Temperature Closed-Loop Control System During Burn-in Test

Global Annealing Strategy: Evolutionary Circuit Design Made Efficiently.

Burn-in effect in InGaP/GaAs HBT with intrinsically or extrinsically carbon doped base layer

Seeds optimization algorithm of SIC test sequences in low power BIST