Abstract:Bridge vehicle-load and damage-condition information plays a vital role in the structural analysis and assessment of bridges. This information can be derived from bridge responses (such as displacement, acceleration, and strains). Most existing bridge damage and load identification methods are based on different measurements from both the bridge damage and load subsystems (different sensors and methods) in the literature. Accordingly, more sensors and measuring activities are required; therefore, the costs associated with structural health monitoring tend to rise. This paper proposes a new method for the synchronous identification of damage and vehicle loads on simply supported bridges, which uses just one set of long-gauge fiber Bragg grating (FBG) sensors and reduces the use of sensing devices, sensors, and costs. In the proposed method, the correlations among the peak values of static macrostrain curves, bending stiffness of bridge cross sections, and vehicle loads are established based on the macrostrain influence line theory. A numerical case study of a 30-m simply supported bridge, subject to moving vehicles, is performed to preliminarily validate the effectiveness of the proposed method. In this case, the damage identification error is below 6%, and the load identification error is less than 4%. In addition, a laboratory experiment including a model bridge and car is conducted to further examine the feasibility of this method in engineering practice, and the results show that the model bridge damage and load can be identified synchronously with good accuracies. (C) 2019 American Society of Civil Engineers.

Damage Detection Strategy Using Strain-Mode Residual Trends for Long-Span Bridges

Distributed Strain Damage Identification Technique for Long-Span Bridges under Ambient Excitation

Vibration-Based Damage Detection Of Cable-Stayed Bridges

Energy Damage Detection Strategy Based on Acceleration Responses for Long-Span Bridge Structures

Quasi-Static Macrostrain-Based Structural Damage Detection With Distributed Long-Gauge Fiber Bragg Grating Sensing

Damage detection strategy for long-span bridge based on strain energy distribution change

Synchronous Identification of Damage and Vehicle Load on Simply Supported Bridges Based on Long-Gauge Fiber Bragg Grating Sensors

Strain-Based Damage-Assessment Method for Bridges under Moving Vehicular Loads Using Long-Gauge Strain Sensing

Damage Detection for Long-Span Cable-Stayed Bridge

Sensitivity Analysis of Acceleration-based Energy Damage Detection Strategy to Load Excitations and Sensor Placement

Operational Damage Detection Technique For Urban Highway Bridge Using Distributed Strain

Structural Identification and Damage Detection Through Long-Gauge Strain Measurements

Structural Damage Detection Based on Structural Macro-Strain Mode Shapes Extracted From Non-Stationary Output Responses

Damage Detection Method for Long Span Cable-Stayed Bridge Based on Model Updating

Two-Level Damage Detection Strategy Based on Modal Parameters from Distributed Dynamic Macro-Strain Measurements

Damage Detection in Long Suspension Bridges Using Stress Influence Lines

New Approach for Strain Modal Measurement and Damage Detection of Bridges

Damage Identification of a Long-Span Suspension Bridge Using Temperature-Induced Strain Data

Damage Identification of Long-Span Bridges Based on the Correlation of Probability Distribution of Monitored Quasi-Static Responses

Damage identification of T-beam bridge based on distributed long-gauge strain mode theory

Stiffness Monitoring and Damage Assessment of Bridges under Moving Vehicular Loads Using Spatially-Distributed Optical Fiber Sensors