Abstract:High strength-elongation synergy and its dependence on microstructure are the eternal themes of metallic materials including Ti alloys. In this study, the relationship between the microstructure evolution and mechanical properties of the Ti-25Zr-4Al-1.5Mn (TZAM, wt. %) near-α Ti alloy was systematically investigated after hot rolling at temperatures ranging in the whole solid solution region. The content of primary α phase decreased gradually with the increasing of rolling temperature. An excellent comprehensive mechanical properties with a yield strength of 1055±10 MPa and a total elongation of 23.6±0.6% were obtained for the specimen after rolling at 750 °C (single α phase temperature region). This great strength-elongation synergy is mainly due to the synthetic action of substructure strengthening, dislocation strengthening, basal random heterogeneity (BRH) texture, and suitable content of β phase. The α" martensitic phase was formed after rolling at temperatures of 800 and 850 °C (α + β two-phase temperature region), resulting in a significant decrease in yield strength. However, remarkable work hardening with a rate of approximately 10 GPa occurred in both specimens. The whole evolution process of primary α grains, namely dynamic recovery and recrystallization during hot-rolled is deeply discussed. When the rolling temperature increased to 900 °C (single β phase temperature region), the dominated acicular α´ martensitic phase with high dislocation density resulted in an ultra-high strength (1264±12 and 1488±11 MPa for yield and tensile strength respectively) at the expense of plasticity. These findings revealed the microstructure evolution and its relationship to the mechanical properties of a TiZr-based alloy after the thermomechanical processing and helped to understand deeply the theory of metallic strengthening and elongation.

Preparation and Properties of La-Tzm Alloy Plates

Preparation and Oxidation Behavior of La-Tzm Alloy Plates

Preparation and Mechanical Properties of La-TZM Alloy Sheet

Preparation and ductile-to-brittle transition temperature of the La-TZM alloy plates

Effect of Lanthanum Doping Method on Properties of La-TZM Alloy

Fracture and Microstructure of La Doped TZM Plate

High Temperature Mechanical Properties of TZM Alloys under Different Lanthanum Doping Treatments

Preparation and Properties of La-TZM Alloy by Substitution of Organic Carbon for Graphite

Pt-plating effect on La-TZM alloy high temperature oxidation behavior

Microstructure of La-TZM alloy doped with rare-earth oxide La 2O 3

Microstructure Regulation and Strength-Elongation Synergy of the Near Alpha TZAM Alloy Via Thermomechanical Processing

Electrochemical Behavior and Microstructural Characterization of Lanthanum-Doped Titanium-Zirconium-molybdenum Alloy

Effects of Rare Earth La Element Doping on Recrystallization Behavior of TZM Alloy Sheet

Fracture behavior of the La-doped molybdenum-titanium-zirconium alloy

Microstructure of La-TZM alloy doped with rare-earth oxide La203

La2O3 Effects on TZM Alloy Recovery, Recrystallization and Mechanical Properties

Effect of La2 O3 on recrystallization temperature of TZM alloy

Development of High-Strength, Low-Cost Wrought Mg–2.5mass% Zn Alloy Through Micro-Alloying with Ca and La

Investigation on Compression Behavior of TZM and La 2 O 3 Doped TZM Alloys at High Temperature

Secondary phases formation in lanthanum-doped titanium-zirconium-molybdenum alloy

TZM ALLOY AND ITS PROPERTIES