Abstract:In this paper, the effects of different rare earth elements (La, Ce, Sm and Er) on the microstructure and mechanical properties of Al-6.7Zn-2.6 Mg-2.0Cu-0.1Zr alloys have been investigated. The results show that the addition of rare earth elements, especially those with a higher atomic number (La < Ce < Sm < Er), could effectively reduce the alloy grain size. Rare earth elements form Al11La3, Al4Ce, Al10Cu7Sm2 and Al8Cu4Er phases in the alloy. After being rolled, the small rare earth phases could pin the grain boundaries, inhibit recrystallization, and refine the structure during solid solution treatment. Moreover, the rare earth atoms would provide more nucleation sites for the precipitation of the η' phase to make it smaller during the aging treatment. Therefore, the rare earth elements can significantly improve the mechanical properties of the alloy through grain refinement and precipitation strengthening. Because Er has a lower solid solubility in Al matrix than other elements, and can form Al3 (Er, Zr) phase, this phase can effectively inhibit recrystallization behavior. Therefore, among all the studied rare earth elements, Er has the strongest strengthening effect, which increases the tensile strength and yield strength of the alloy by 40Mpa and 29Mpa, respectively. The Sm-containing alloy acquire more fine recrystallized grains after solid solution, so that the elongation of the alloy is increased to 14.3%, and its plasticity is the best.

Microstructure of La-TZM alloy doped with rare-earth oxide La203

Ball milling assisted preparation of nano La–Y/ZrO2 powder ternary oxide system: Influence of doping amounts

Effect of rare earth oxide doping on microstructure and mechanical property of Mo-30 W solid solution alloy

Secondary phases effects on microstructure and mechanical properties of lanthanum-doped titanium‐zirconium‐molybdenum alloy

Promoting the La Solution in 2:14:1-Type Compound: Resultant Chemical Deviation and Microstructural Nanoheterogeneity

Effect of Ti Addition on the Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn Alloys

The effect of doping Ag on the microstructure of La 2/3 Sr 1/3 MnO 3 films

Grain refinement of additive manufactured Ti-6.5Al-3.5Mo-1.5Zr-0.3Si titanium alloy by the addition of La2O3

Study on the Mutual Effect of La and Gd on Microstructure and Mechanical Properties of Mg-Al-Zn Extruded Alloy

The formation mechanism of Al-RE tubular phase in AZ80-Ce magnesium alloy by La doping

Study on Phases Formation and Modification Ability of Rare Earth Elements La, Ce, Sm and Er in Al–Zn–Mg–Cu–Zr Alloy

The formation mechanism of micro-nano secondary phase in solid-liquid doped TZM alloy

Effect of La2O3 on Microstructure and Thermal Conductivity of La2O3-Doped YSZ Coatings

INFLUENCE OF SMALL AMOUNT OF DOPANT ON GRAIN SIZE AND PHASE COMPOSITION OF 8 % Mg- PARTIALLY STABILIZED ZIRCONIA

Enhancement of the corrosion resistance of Molybdenum by La2O3 dispersion

The effect of microstructure on the doped lanthanum zirconates transport properties

Evaluation of tensile property and strengthening mechanism of Zirconia reinforced molybdenum alloy

Microstructures of Zn,Ni,Mg Doped La1.85sr0.15cuo4 in High Doping Level

Study on Elemental Composition and Interfacial Structure of the Second Phase in WC-8Co Hard Alloy Doped with Rare Earth Components

MECHANICAL ALLOYING PREPARATION OF PLZT POWDER BY MULTI-DIMENSIONAL VIBRATION MILLING

Effects of Rare Earth Elements and Ti on Microstructure and Properties of ZM5 Magnesium Alloy