Abstract:Numerical simulations of the cutting process play a key role in manufacturing and cost optimization. Inherent in finite element analysis (FEA) simulations is the correct description of material behavior during machining. For this purpose, various material models are used to describe the behavior of the material in the range of high deformation, high temperature values, and high strain rates. Very often the Johnson–Cook (JC) material model is used for this purpose; however, the correct determination of the material constants of this model is a key aspect. Therefore, this paper presents a procedure for determining the material constants of the JC model using an analytical method based on normalized tensile and compression testing of the material for different strain rates over a wide temperature range. After determining the material constants, the authors conducted numerical simulations of the orthogonal turning of Ti6Al4V titanium alloy using the obtained constants. Validation of the obtained results with those obtained in experimental studies was also carried out. The outcomes demonstrated that the difference between FEM simulation and experimental tests did not exceed 0.02 mm (14%) in the case of chip thickness,. Much smaller differences were obtained for the temperature in the cutting zone, where the maximum difference was about 45 °C (4%). Comparing the components of the cutting force, we found that, in the case of the main cutting force, in most cases, the differences did not exceed 70 N (8%). After the verification of the obtained results, it was also found that the determined material constants of the Johnson–Cook model can be successfully used in FEM modeling of the cutting process of Ti6Al4V titanium alloy for the adopted range of values of technological parameters.

Determination of Flow Stress Based on Cutting Simulation and Optimization

Determination of the Flow Stress of Ti6Al4V Based on Cutting Experiment and Optimization

Research on the Flow Stress Model of Titanium Alloy TC4 During the Cutting Process

Simulation of High-Speed Milling Process of Aerospace Aluminum Alloy

Numerical simulation on surface residual stress for titanium alloy

Extrapolation Based Constitutive Modeling of Flow Stress of Titanium Alloy Sheet under Hot-Working Condition

Microstructure Sensitive Flow Stress Based on Self Consistent Method

A Hybrid Cutting Force Model for High-speed Milling of Titanium Alloys

A New Microstructure-Sensitive Flow Stress Model for the High-Speed Machining of Titanium Alloy Ti–6Al–4V

Simulation of Material Side Flow Using a 3D Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the Stress State

Finite element simulations of Ti6Al4V titanium alloy machining to assess material model parameters of the Johnson-Cook constitutive equation

Determination and Verification of the Johnson–Cook Constitutive Model Parameters in the Precision Machining of Ti6Al4V Alloy

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Inverse determination of improved constitutive equation for cutting titanium alloy Ti-6Al-4V based on finite element analysis

Machining Simulation of Ti6Al4V Using Coupled Eulerian-Lagrangian Approach and a Constitutive Model Considering the State of Stress

Finite Element Simulation and Analysis of the Chip Formation of Ti6Al4V Based on J-C Model

Two Methods for the Constitutive Modeling of TiB2/7050 Al Composites

Subroutine Embedding and Finite Element Simulation of the Improved Constitutive Equation for Ti6Al4V during High-Speed Machining

Determining Al6063 Constitutive Model for Cutting Simulation by Inverse Identification Method

Machining mechanism and stress model in cutting Ti6Al4V

Constitutive Model and Cutting Simulation of Titanium Alloy Ti6Al4V after Heat Treatment