Abstract:<p>Tungsten-particle (Wp)-reinforced bulk-metallic-glass composites (Wp/BMGCs) with a Wp volume fraction of 0%–50% were prepared by spark plasma sintering (SPS). The sintering process parameters were optimized through an orthogonal experiment. With increasing volume fraction of Wp, the compressive yield strength of the Wp/BMGCs decreased, while their ultimate strength and plastic strain increased. Nanoindentation experiments revealed that the elastic modulus and hardness of the composites increased with increasing volume fraction of Wp. The elastic modulus mismatch between the tungsten particles and metallic glass matrix resulted in a stress concentration at the interface of the two phases, promoting the initiation and propagation of shear bands in the metallic glass matrix. Fracture morphology analysis of the composites showed that the failure mode of the composites was shear fracture mode, which is beneficial to the self-sharpening of the composites. With increasing volume fraction of Wp, the plastic deformation of Wp became more obvious, and the deformation was most obvious near the shear fracture surface. The degree of plastic deformation of Wp in the region far away from the shear fracture surface gradually decreased. In addition, the reliability of the mechanical properties of Wp/BMGCs prepared by different SPS sintering processes was verified by three-parameter Weibull statistical analysis. These results help deepen our understanding of the preparation and mechanical properties of Wp/BMGCs and further promote their application.</p>

Experimental Investigation of Tensile Properties and Fracture Mechanism of WCP/Cu Composites Reinforced with Different WCP Volume Fraction

Fracture Behavior of Cu/Cu–WCP Layered Composites

Insight into the Microstructure and Tensile Behavior of the W–Cu Composite Reinforced with Tungsten Fibers and Particulates

Dynamic Mechanical Properties and Fracture Characteristics of Tungsten Fiber Reinforced Cu-Based Composites

Preparation and mechanical property of W f/Cu alloy matrix composites

Experimental study on tension and compression mechanical property of 3D fine woven punctured C/C composites

Effect of Heating Process on Fracture Behaviors of Wf/Cu82Al10Fe4Ni4 Composites

The effect of interface modification on fracture behavior of tungsten fiber reinforced copper matrix composites

Microstructure and mechanical properties of 20Wf/30ZrCp/W composite

Study of Friction and Wear Properties of Cu/Short Carbon Fibers Composites

Tensile Properties and Fracture Behavior of Laser Cladded WC/Ni Composite Coatings with Different Contents of WC Particle Studied by In-Situ Tensile Testing

Freeze-casted tungsten skeleton reinforced copper matrix composites

Research on dynamic mechanical behavior and damage evolution mechanism of Cu/WCp laminated composites

Microstructural studies of W–10wt.% Cu composites prepared by using ultrafine composite powder

Preparation and mechanical properties of tungsten-particle-reinforced Zr-based bulk-metallic-glass composites

Investigating the Effect of WC Reinforcements in Cu Ti Composite Filler on the Microstructural Evolution and Mechanical Characteristics in Brazing Cf/SiC and GH3536

Numerical investigations on the hybrid effect and deformation mechanism of TiB2p and TiBw reinforced Cu composites prepared by in-situ mixing casting

Microstructure and Properties of W Cu Composites with Low Copper Content at Different Sintering Temperatures

Microstructures and Mechanical Properties of ZrCP/W Composites at Room Temperature

Tribological and Electrochemical Corrosion Behaviors of Cu-based Powder Metallurgy Composites Reinforced by In-Situ WC with Different Morphology

Investigation for the Fracture Process of WCp/Cu Functionally Graded Materials under Three-Point-Bending