Abstract:An increase in hydrostatic stress improves the plasticity of metallic materials. However, for some special components, such as large thin-walled components with high ribs, excessive hydrostatic stress can cause several problems that make it impossible to prepare such components using plastic forming methods. In this study, the effect of hydrostatic stress on the deformation behavior of large thin-walled components with high ribs was investigated using a combination of numerical simulations and theoretical derivations. The results indicated that excessive hydrostatic stress leads to die failure, causing metal flow difficulties, uneven deformation, inconsistent mechanical properties, and reduced forming accuracy. Therefore, a low-hydrostatic-stress extrusion method was proposed by adjusting the contact friction, metal flow direction and displacement, and force boundary conditions to reduce the hydrostatic compressive stress. These principles are mainly reflected in the following three aspects: First, the size of the difficult deformation zone was reduced by changing the friction conditions from dry friction to fluid friction or boundary friction to reduce the frictional resistance. Second, the high-stress zone was eliminated by changing the metal flow direction, adjusting the strain state from unidirectional to multi-directional flow, shortening the metal flow path, and reducing the metal flow resistance. Third, the strong compressive stress state in the three directions was weakened by regulating the force boundary conditions and changing the loading method from one-way extrusion to multi-directional loading. Based on these principles, a series of new forming technologies have been developed, such as actively counteracting frictional resistance, slotting, and ditching on dies for long-lasting lubrication, multi-directional short-range metal flow, drawing-assisted extrusion, and multi-directional active loading. The adoption of these technologies realizes the labor-efficient formation of large thin-walled components with high ribs and provides the formed members with high precision and uniform mechanical properties.

Study on Cross Section Geometry of Preform for the Forming Laws of A Symmetrical Rib-Web Component

Flow defects of rib-web components in isothermal local-loading forming process

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Optimization of the Forming Method on Torsion Defect in Cold-Roll Forming of Z Section Steel

Study on warm forming process of rigid-flexible composite drawing based on numerical simulation

Study on multi-roller flow forming process of aluminum alloy cylinders with cross ribs

Research on the Mechanism and Processability of Roll Forming

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

Numerical and experimental investigation on precision forming of ribbed tube by cold drawing process

A non-sequential isothermal local-loading forming process for large-scale rib-web components

Study on hydroforming of AA6061-T6 aluminum alloy sheet based on upper sheet

Web crippling investigation of perforated aluminium lipped channels under interior-one-flange loading condition

Investigation on low hydrostatic stress extrusion technology for forming of large thin-walled components with high ribs

Multi-pass rolling-extrusion of large-scale thin-walled square tube with longitudinal inner ribs

Experimental characterization and numerical analysis of 3D woven preforms torsional deformation

Cisapride stimulates motility of the intestine via the 5-hydroxytryptamine receptors.

Deformation mechanism of ZK61 magnesium alloy cylindrical parts with longitudinal inner ribs during hot backward flow forming

Analysis and experiment on tube hydroforming in a rectangular cross-sectional die

Experimental and numerical investigations into the ductile fracture during the forming of flat-rolled 5083-O aluminum alloy sheet

Activation of the amino acid-incorporating system of rat liver slices upon incubation.

Effect of cold process drawing parameters on the formability and microstructure of ribbed cladding tubes