Abstract:In this work, we present a fabrication procedure of metal nanomesh arrays with the newly developed nanoimprint resist mr-NIL212FC used in a bi-layer resist system for a lift-off process. We comparatively analyzed and evaluated nanomeshes fabricated with a freshly prepared h-PDMS/PDMS stamp and a stamp used 501 times. Therefore, we first performed a step&repeat imprint test run in a self-built low cost step&repeat UV-NIL setup. We inspected the imprint behavior of the stamp, the UV-transmission through the stamp as well as stamp lifetime and stamp degradation with regard to the possible changes of its surface roughness. The nanomesh fabrication process is characterized by a good lift-off performance, leading to a low defect density of < 1.26 defects/100µm2. Even after 501 imprints, only a negligible stamp degradation occurred without effecting the imprint performance. Likewise, the same holds true for the nanomeshes, which showed comparable low defect densities and feature sheet resistances of 3.54±0.14 Ω/□ for the first and 3.48±0.23 Ω/□ for the 501st nanomesh, respectively. AFM analyzes further revealed that the maximum height of the roughness Rt changed over the course of the 501 imprints from 6.3 nm to 13.3 nm, representing < 5% of the overall imprint height. In general, the mr-NIL212FC resist shows a good wettability and compatibility with standard h PDMS/PDMS stamps, a fast curing behavior, a high replication fidelity, easy separation characteristics, and a very low diffusion of resist components into the stamp. The mr-NIL212FC resist allows exposure times as short as 2 seconds in the applied tool setup, enabling high throughput production. Moreover, all performed measurements indicate that a much higher number of imprints with one stamp seem possible.

Application of Lift-Off Process in Fabricating Nanoimprint Stamp

Dynamics of Liquid Transfer from Nanoporous Stamps in High-Resolution Flexographic Printing

Self-Collapse Lithography

Research on the Filling Process of Ultraviolet Nanoimprint Lithography with High-Resolution Stamps

Micro-print and nano-imprint methods combining laser-drilled screen printing and ultraviolet nanoimprint lithography: a review

Fabrication of Large-Area Nanostructures Using Cross-Nanoimprint Strategy

Development of Novel SU-8 Based Nanoimprint Lithography

Fabrication of sub-50 nm nanochannel array by an angle forming lift-off method

Double transfer UV-curing nanoimprint lithography.

Nanoimprint lithography technology

Fast Fabrication of Tio2 Hard Stamps for Nanoimprint Lithography

UV-based nanoimprinting lithography with a fluorinated flexible stamp

Fabrication of 2D silicon nano-mold by side etch lift-off method

Fabrication of Nanostructures on a Large-Area Substrate with a Minimized Stitch Error Using the Step-and-Repeat Nanoimprint Process

Scalable Lithography From Natural Dna Patterns Via Polyacrylamide Gel

Development of a soft UV-NIL step&repeat and lift-off process chain for high speed metal nanomesh fabrication

Fabrication of Nanoimprint Mold by Multilayer Film Deposition Technique

Utilization of Resist Stencil Lithography for Multidimensional Fabrication on a Curved Surface

Hybrid Nanoimprint-Soft Lithography for Highly Curved Surface with Sub-15 Nm Resolution

Hybrid nanoimprint-soft lithography with sub-15 nm resolution.

Nanoimprinting and backside ultraviolet lithography for fabricating metal nanostructures with higher aspect ratio