Abstract:In this paper, a high-resistivity silicon (HR-Si) interposer integrated with through-silicon via (TSV) electrically grounded coplanar waveguide (CPW) line is presented for 2.5-D/3-D heterogeneous integration of radio frequency (RF) microelectronics devices. In addition, design of TSV interconnection composed of two coaxial ladder-hollow-annular Cu (copper) TSVs of different diameters is utilized to maintain a sufficient freedom for strict standard cleaning to avoid Si resistivity degradation. The formation of the coaxial ladder TSV structure is more beneficial to the subsequent plating process because it reduces the aspect ratio of TSV vias. Hollow-annular Cu TSV is manufactured in order to reduce the problem of mismatch in coefficient of thermal expansion among TSV's constituent materials. A layer of Au (aurum) film is utilized to passivate the exposed Cu surface of Si interposer. Au is widely used in III-V groups' devices because of the good compatibility with photonic integrated circuits, conductivity, and corrosion resistance. HR-Si interposer with TSV grounded CPW line and test structure is fabricated and characterized. With the monitoring test results, it can be found that it changes little in the resistivity of Si substrate, though the whole process, which is a basic requirement for RF performance. RF property test results show that the insertion loss is about -0.20 dB/mm at 10 GHz for the presented TSV grounded CPW line and -0.02 dB per TSV. These test results are better than the traditional design. To verify its applicability to 2.5-D/3-D heterogeneous integration, RF microelectronics die is assembled on TSV interposer and tested, and the test results prove that it works properly.

RF Interconnections for Paper Electronics

RF Interconnections for Paper Electronics

Three-dimensional circuit integration based on self-synchronized RF-interconnect using capacitive coupling

RF-interconnect for multi-Gb/s digital interface based on 10 GHz RF-modulation in 0.18 /spl mu/m CMOS

Two 10Gb/s/pin Low-Power Interconnect Methods for 3D ICs

Research On Smart Sensing Rfid Tags Under Flexible Substrates In Printed Electronics

Co-design of flip chip interconnection with anisotropic conductive adhesives and inkjet-printed circuits for paper-based RFID tags

Advanced RF/baseband Interconnect Schemes for Inter- and Intra-Ulsi Communications

Heterogeneous Integration of Bio-Sensing System-on-Chip and Printed Electronics

System-on-flexible-substrates: Electronics for Future Smart-Intelligent World

Interconnect processes and reliability for RF technology

RFID Tag and RF Structures on a Paper Substrate Using Inkjet-Printing Technology

Low-Capacitance SCR Structure for RF I/O Application

Flexible Electronics: Ultrathin Silicon Circuits with Strain‐Isolation Layers and Mesh Layouts for High‐Performance Electronics on Fabric, Vinyl, Leather, and Paper (adv. Mater. 36/2009)

Integration of F-Mwcnt Sensor and Printed Circuits on Paper Substrate

Facial Fabrication of Paper-Based Flexible Electronics with Flash Foam Stamp Lithography

A 2.5D Integrated L Band Receiver Based on High Resistivity Si Interposer

High Frequency Characterization and Modelling of Inkjet Printed Interconnects on Flexible Substrate for Low-Cost RFID Applications

The Performance of RF Power Couplers with Capacitive Coupling for SRF Accelerators

Low insertion loss interposer approach for RF applications based on commercial LTCC tape, alkaline-free glass and printed metallization

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices