Abstract:A large number of studies have been conducted to investigate the pore structure of cement-based materials with the mercury intrusion porosimetry (MIP) method. However, the conventional MIP method has some drawbacks in the measurement of pore size distributions of most porous materials, including cement-based materials. This is mainly because of the lack of direct accessibility of most pore volumes. This paper reports an alternative method to investigate the pore structure with conventional MIP set-up but different testing sequence and different data analysis method. By repeating the intrusion and extrusion cycles in every pressure step, the volume of throat pores and the volume of corresponding ink-bottle pores can be determined at each pore diameter. With the assumption that the size distribution of these ink-bottle pores at each pore diameter is equal to that of the pores larger than the corresponding throat pores, the pore size distribution can be recalculated. The new MIP method is used to investigate the pore structure of Portland cement pastes. The results measured with the new MIP method are compared with those determined with conventional MIP method and backscanning (BSE) image analysis. It is found that the new and conventional MIP measurements give the same total porosity and BSE image analysis gives a relatively lower total porosity. Regardless of the curing age, the result of the new MIP method shows a critial pore diameter smaller than that of the old method and larger than that of the BSE image analysis.

New Pore Structure Assessment Methods for Cement Paste

Experimental Study and Analytical Model for Pore Structure of Hydrated Cement Paste

Determining Porosity and Pore Network Connectivity of Cement-Based Materials by a Modified Non-Contact Electrical Resistivity Measurement: Experiment and Theory

Pore structure characterization of cement paste by different experimental methods and its influence on permeability evaluation

Investigations on Three-Dimensional Pore-Structure in Cementitious Materials Using Metal Centrifugation Porosimetry and Simulation

Pore Structure Damages In Cement-Based Materials By Mercury Intrusion: A Non-Destructive Assessment By X-Ray Computed Tomography

Empirical Estimation of Pore Size Distribution in Cement, Mortar, and Concrete

New mercury porosimetry method for the measurement of pore size distribution in cement-based materials

Fractal Characterization of Pore System Evolution in Cementitious Materials

Continuous Characterization of Pore Structure in Cement Paste

Critical Features of Microstructure Development of Early-Age Cement Paste Revealed by Non-Contact Electrical Resistivity Measurement

Pore Structure of Cement Pastes Through NAD and MIP Analysis

Solid Mass Fractal Model for Pore Structure in Cement Paste

Fractal Modeling of Pore Structure and Ionic Diffusivity for Cement Paste

Three-Dimensional Modeling of Transport Properties in Hardened Cement Paste Using Metal Centrifugation-Based Pore Network

Quantitative Characterization of Pore Morphology in Hardened Cement Paste Via SEM-BSE Image Analysis

Reassessment of mercury intrusion porosimetry for characterizing the pore structure of cement-based porous materials by monitoring the mercury entrapments with X-ray computed tomography

Characterizing Pore Structure of Cement Blend Pastes Using Water Vapor Sorption Analysis

Statistical Modeling of Pore Structures in Fresh Cement Paste Based on Dispersion Theory of Random Two-Phase Media

Prediction of Effective Chloride Diffusivity of Cement Paste and Mortar from Microstructural Features

Investigations on pore-structure in cementitious materials using gas intrusion porosimetry