An electrophoretic ion analyzer for on-site autonomous water monitoring
Shuai Liu,Zhen Pan,Ying Liang,Feng Li,Michael C Breadmore,Min Zhang,Michael C. Breadmore
DOI: https://doi.org/10.1016/j.chroma.2020.461791
IF: 4.601
2021-01-01
Journal of Chromatography A
Abstract:<p>An on-site ion analyzer based on capillary electrophoresis with pressure-driven flow through injection and capacitively coupled contactless conductivity detection has been developed for field monitoring of cations and anions in environmental waters. Automated time-pressure based hydrodynamic injection provides stable pL-nL scale injection (RSD = 1.96%, n = 30). A mixture of 400 mM Bis-Tris, 400 mM MOPS and 2 mM 18-crown-6 is used as the background electrolyte to provide repeatable separations. A proprietary hydrophilic coated 25 μm id capillary is used to suppress the electroosmotic flow. Separations of anions (Cl<sup>-</sup>, NO<sub>3</sub><sup>-</sup>, NO<sub>2</sub><sup>-</sup>, SO<sub>4</sub><sup>2-</sup>, F<sup>-</sup> and PO<sub>4</sub><sup>3-</sup>) and cations (NH<sub>4</sub><sup>+</sup>, K<sup>+</sup>, Na<sup>+</sup>, Ca<sup>2+</sup> and Mg<sup>2+</sup>) were achieved by switching the polarity of the high voltage power supply in two individual runs. Signal fluctuations caused by the temperature or viscosity changes in on-site monitoring are corrected by on-line introduction of internal standards. RSDs of the migration time and the corrected peak height over ∼35 h and 350 analysis cycles are <4.06%. The LODs of inorganic ions are in the range of 2.1 μM (K<sup>+</sup>) to 6.8 μM (PO<sub>4</sub><sup>3-</sup>). The feasibility for on-site water monitoring with this system has been validated by a standard Ion chromatography method with comparable results obtained.</p>
chemistry, analytical,biochemical research methods