Abstract:Age hardening at 160 degrees C was performed in an Al-6.0 wt.%Zn-2.3 wt.%Mg-I.8 wt.%Cu-0.1 wt.%Zr alloy. It was found that metastable phases played a very important role in controlling this behaviour. The alloy reached the 193 HV peak hardness aged for 6 h. Transmission electron microscopy was used to characterise the morphology of iy phases as main strengthening precipitates, and then the high-resolution transmission electron microscopy, combining with Transition Matrix calculation, was used to analysis the orientations and electron diffraction patterns of eta' precipitates. It was found that the eta' phases in four variants had only three different zone axis: [2 (4) over bar 23](eta'), [10 (1) over bar0] T and [(2) over tilde4 (2) over bar3](eta'), parallel to the [110](Al) direction of Al matrix when they were precipitated. By integrating the atomic coordinates, structure factors and double diffraction effect, a new diffraction patterns model under the [110](Al) zone axis was established, which was good in agreement with the experimental result. Simultaneously, Moire fringes analytical technique was also used to quantitatively verify the lattice parameters and orientation variants of eta' precipitates, and demonstrated that Moire fringes with about 0.7 nm spacing were the results of the interaction between the 0004(eta')/4000 (4) over bar (eta'), diffraction eta' of Ti' precipitates in variants 3/4 under the [10 (1) over bar0] y zone axis and the 1 (1) over bar (Al)/1 (1) over bar(1) over bar (Al) of Al matrix under the [110](Al) zone axis. Furthermore, the high-resolution transmission electron microscopy image simulation for Moire fringes of eta' precipitates in the Al matrix presented a good match with the experimental result. (C) 2014 Elsevier B.V. All rights reserved.

Precipitation Sequence of Η Phase along Low-Angle Grain Boundaries in Al-Zn-Mg-Cu Alloy During Artificial Aging

Atomic-scale study on the precipitation behavior of an Al-Zn-Mg-Cu alloy during isochronal aging

Evolution of Precipitate and Precipitate/matrix Interface in Al-Zn-Mg-Cu(-Ag)alloys

Precipitation in an Al-Zn-Mg-Cu alloy during isothermal aging: Atomic-scale HAADF-STEM investigation

Precipitation Process along Dislocations in Al–Cu–Mg Alloy During Artificial Aging

Nucleation and evolution mechanism of precipitates during the initial aging stage in Al-Zn-Mg-Cu alloy

Accelerated Precipitation and Growth of Phases in an Al-Zn-Mg-Cu Alloy Processed by Surface Abrasion

Precipitation in a CuCrZrMg alloy during aging

Early-stage precipitation in Al?Zn?Mg?Cu alloy (7050)

Reinterpretation of Precipitation Behavior in an Aged AlMgCu Alloy

Precipitation behavior in the early stage of aging in an Al–Li°Cu–Mg–Zr–Ag (Weldalite 049) alloy

Transformation behavior of precipitates during artificial aging at 170 °C in Al–Mg–Si–Cu alloys with and without Zn addition

The Effect of Cu Addition on the Precipitation Sequence in the Al-Si-Mg-Cr Alloy

Precipitation Behavior of Mg-7Gd-3Y-2Zn-0.5Zr Alloy during Isothermal Aging

Segregation assisted grain boundary precipitation in a model Al-Zn-Mg-Cu alloy

Small-angle X-ray Scattering Study of Precipitates in AlZnMgCu-1.0 Wt.% Li Alloy

Precipitation Behaviour of Al–Zn–Mg–Cu Alloy and Diffraction Analysis from Η′ Precipitates in Four Variants

Complex Precipitation Sequences of Al-Cu-Li-(Mg) Alloys Characterized in Relation to Thermal Ageing Processes

Early-stage Clustering and Precipitation Behavior in the Age-Hardened Al–Mg–Zn(-Cu) Alloys

Co-precipitation of T′ and η′ phase in Al-Zn-Mg-Cu alloys

Precipitation Behavior during Aging Operations in an Ultrafine-Grained Al–Cu–Mg Alloy Produced by High-Strain-Rate Processing