Abstract:Low-temperature-initiated cracking technology has significant potential to develop new hydrocarbon pyrolysis with better atomic economy and higher yields of light olefins. The impacts of three representative initiators, triethylamine (TEA), nitromethane (NM), and di-tert-butyl peroxide (DTBP), were compared. Sufficiently detailed co-cracking reaction networks of three initiators with n-hexane were obtained through an automatic reaction network generator RMG, and the corresponding steam cracking tubular reactor simulation was performed. The results showed that the initiator with a lower cracking temperature brought about a more noticeable decrease in the cracking temperature of n-hexane. Both TEA and NM increased the carbon atom conversion from n-hexane to ethylene and propylene, especially propylene. NM was more significant, while DTBP was almost ineffective. Through kinetic parameter analysis, it was found that the temperature dependence of the key reaction caused different initiator performance. NM completely cracked at an appropriate temperature where the rate constants of the hydrogen abstraction and ethylene generation had reached a high level, and the released free radicals were effective. Visual reaction network analysis revealed that NM had a strong ability to release free radicals, and these free radicals significantly adjusted the competitive reaction path to produce ethylene and propylene, resulting in the most obvious effect on improving the conversion of n-hexane and the yield of propylene. The action laws of NM described above under hydrocarbon pyrolysis conditions indicate that NM may be the most suitable initiator for low-temperature-initiated cracking of hydrocarbons among these three initiator types.

Synthesis of Poly Alpha Olefins Using Alpha Olefins Obtained from the Steam Cracking Process of Coal Liquefaction Wax

Preparation of Α-Olefins Through the Steam Cracking Process of Wax from Coal Liquefaction

Study on Synthesis and Application of Poly Alpha Olefins Based on Alpha Olefins Produced from Coal Liquefied Wax Cracking Process

Low-Temperature-Initiated Cracking of Hydrocarbons to Produce Olefins: Simulation and Comparison of Different Initiators

Synthesis of Polyalphaolefins on AlCl3/TiCl4 Catalyst

Study on hydroformylation synthesis of higher alcohol with olefins from paraffin cracking

Commercial experiment of synthesis of 8b and 20# aviation engine oils

Study on the technology of thermal cracking of paraffin to alpha olefins

Separating Group Compositions in Naphtha by Adsorption and Solvent Extraction to Improve Olefin Yields of Steam Cracking Process

Influence of temperature, residence time, and solvent/feedstock mass ratio on overall product distribution and oil products quality in ethanol liquefaction of 230 polypropylene impact copolymer

SEPARATING GROUP COMPOSITIONS IN NAPHTHA TO IMPROVE OLEFIN YIELDS OF STEAM CRACKING PROCESS

Experimental Investigation and Modeling of Steam Cracking of Fischer–Tropsch Naphtha for Light Olefins

Preparation and Characterization of Single-Component Poly-α-olefin Oil Base Stocks

Low-temperature upcycling of polyolefins into liquid alkanes via tandem cracking-alkylation

Controlling the Wax Crystallization Behaviors Via the Ratio of Phenyl to Aliphatic Branches in Block Copolymer Synthesized by RAFT Copolymerization

THERMODYNAMICS ANALYSIS AND REACTION PERFORMANCE OF THE PRODUCTION OF PROPYLENE AND ETHYLENE FROM C4OLEFINS CRACKING

Study on Preparation Process of Lubrication from 1-Decene with Acidic Ionic Liquid Catalyst

Ultra‐Narrow Alkane Product Distribution in Polyethylene Waste Hydrocracking by Zeolite Micropore Diffusion Optimization

Fischer-Tropsch wax catalytic cracking for the production of low olefin and high octane number gasoline: Experiment and molecular level kinetic modeling study

Economic Benefit Analysis of Cracking n-Alkane Enriched by Absorption from Naphtha to Produce Olefin

Biogasoline Production from the Co-Cracking of the Distilled Fraction of Bio-Oil and Ethanol