Abstract:The effects of carbon chain length of alcohol and reaction temperature on catalytic conversion of alcohols to produce aromatics over HZSM-5 were studied in a micro fixed-bed reactor coupled directly to GC/MS system.The results showed that the carbon chain length of alcohol had a significant effect on the product distribution.At 400℃,with the increase of carbon chain length of alcohol,the yield of aromatics increased firstly up to the maximum of 39.6％ (1-propanol),then decreased and finally stabilized at a lower yield.As the temperature increased,the products distributions for methanol,ethanol,1-propanol showed the same tendency,and the yields of aromatics increased firstly,then decreased and the maximum values reached 26.0％,36.5％ and 42.5％ at 500℃ respectively.As the temperature increased,however,the yield of CO,CO2 and olefins increased gradually while the total yield of hydrocarbons decreased.Higher temperature helped the conversion of larger aromatics to lighter aromatics,which contributed to the higher selectivity for benzene and toluene.Finally,the reaction mechanism of alcohol aromatization was discussed by the combination of in-situ FTIR and experimental results.It is supposed that the light olefins and ethers were produced by dehydration of short carbon chain alcohols,while long carbon chain olefins were produced by polymerization of the light olefins or direct dehydration of long carbon chain alcohols.The obtained long carbon chain olefins were then converted into cycloalkanes by cyclization.At last,aromatics were formed by dehydrogenation-aromatization or intermolecular hydrogen transfer of the cycloalkanes.

Study on hydroformylation synthesis of higher alcohol with olefins from paraffin cracking

Study on in-situ catalytic conversion of alcohols to aromatics and its mechanism

Study on the influence of low-carbon alcohol on non-hydrodewaxing reaction of hydrocracking tail oil

Study on the technology of thermal cracking of paraffin to alpha olefins

Preparation of Α-Olefins Through the Steam Cracking Process of Wax from Coal Liquefaction

Synthesis of Poly Alpha Olefins Using Alpha Olefins Obtained from the Steam Cracking Process of Coal Liquefaction Wax

Studies of Hydroformylation of Higher Olefins

Study on Synthesis and Application of Poly Alpha Olefins Based on Alpha Olefins Produced from Coal Liquefied Wax Cracking Process

Investigation on the Aqueous-Phase Hydrogenation of Bio-Oil for Saturated Alcohols Production over Ni-B Amorphous Catalysts

The Effect of Additional Zeolites in Amorphous Silica–Alumina Supports on Hydrocracking of Semirefined Paraffinic Wax

Directional Hydrothermal Hydrogenation of Palmitic Acid to Alcohol over Carbon-Encapsulated Highly Dispersed Co Catalyst

Hydroformylation of Low Molecular Olefins and Preparation of Oxosynthesis Products Based on C4–C5 Aldehydes in the Production of Ester Lubricating Oils. Part I. Catalysts and Industrial Processes

Synthesis of tetrahedrally coordinated CoO for higher alcohol synthesis directly from syngas

Production of alcohols via hydroformylation

Studies on Hydroformylation of Mixed C8 Oiefins

Thermodynamics and Experimental Study of Alcohol Prepared by Synthesis Gas

Hydroformylation of Vinyl Acetate to Α‐acetoxypropanal Catalyzed by a Silica‐supported Polyalumazane‐rhodium Complex

Co-Processing the High-Boiling Fraction of Bio-Oil with Paraffin Oil

Advances in Fischer-Tropsch wax hydrocracking process

Hydrothermal Upgrading of Water-Insoluble Algal Biocrude over Γ-Al2o3 Supported Multi-Metallic Catalysts

Containing Nitrogen and Phosphorus Porous Organic Polymer-Supported Rhodium Catalyst for Hydroformylation of Olefins