Abstract:It can provide theoretical support for the optimal design of low-energy walls by measuring the actual thermal conditions inside the walls of passive low-energy buildings and studying the rationality of the wall structure design. Taking the teaching and laboratory building of Shandong Jianzhu University as an example, this paper explores the method of using temperature and humidity sensor to measure the air temperature and humidity inside the wall to represent the solid temperature and humidity of the wall. Based on the measured data and calculation results, the rationality of the structure of the test external wall is analyzed from four aspects: the performance of insulation, the moisture drain performance of wall, the ability of preventing the penetration of the hot and humid air of the inner wall, and the waterproof performance of the outer wall. Results show that the external wall structure of polystyrene board (200 mm thick) for external insulation and thin plastering has good practical operation effect in three aspects of thermal insulation, internal moisture discharge, and external wall waterproof, which basically meets the design requirements of external wall of passive house in Germany. In terms of moisture protection of the inner wall, the inner wall of cement mortar (15 mm thick) may not be able to effectively prevent the infiltration of indoor hot and humid air. Thus, the insulation layer should be added into the external wall. In addition, the moisture inside the wall is obviously affected by the season. The drain performance of moisture inside the wall mainly occurs in the sweltering heat, and the drain direction is from the indoor side to the outdoor side. In the external insulation structure, there are two layers of graphite polystyrene plate (100 mm thick), and the insulation effect of polystyrene plate near the outdoor side is better than that near the indoor side. The combination of anticrack mortar (5 mm thick) and paint cannot completely prevent the infiltration of rainwater, but the infiltration of rainwater in the wall will be quickly discharged in a short time.

Experimental Study on the Thermal Performance of Ventilation Wall with Cladding Panels in Hot and Humid Area

Temporal variation of wall flow and its influences on energy balance of the building wall

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

Optimum Insulation Thickness of External Walls by Integrating Indoor Moisture Buffering Effect: a Case Study in the Hot-Summer-cold-winter Zone of China

Anti-insulation Behavior for Exterior Wall External Insulation on Residential Buildings in Hot Summer and Cold Winter Zone

Numerical Study on Wall Insulation Construction Affecting the Energy Consumption under the Intermittent and Loculose Energy Use

Study on Energy Saving Effect of Heat-Reflective Insulation Coating on Envelopes in the Hot Summer and Cold Winter Zone

Numerical Study On Energy Consumption Characteristics For Wall Insulation Structure In Hot Summer And Cold Winter Zone

Experimental Study on the Thermal Performance of a Hollow Block Ventilation Wall

Thermal Performance Study on Modular Evaporative Cooling Sandwich Wall on Mechanical Ventilation Condition

Coupled Heat and Moisture Transfer in Walls Featuring Moisture-Buffering Materials and Ventilating Layers: an Experimental Study

Performance study of ventilated energy-productive wall: Experimental and numerical analysis

Study on Thermal Performance Measurement and Construction of Passive Exterior Wall with Low Energy: Teaching and Laboratory Building of Shandong Jianzhu University

Experimental study on the performance of a novel RC-PCM-wall

An Experimental Investigation into Stratum Ventilation for the Cooling of an Office with Asymmetrically Distributed Heat Gains

Study on optimization of thermal property parameters of phase change wallboard and its application simulation in the building

Research on improving thermal performance of prefabricated sintered hollow wallboard with optimizing filling materials

Experimental and numerical study on indoor thermal environment of solar Trombe walls with different air-channel thicknesses in plateau

Study on the heat transfer of a concrete wall outfitted with phase change materials

Study on heat transfer of light steel-framed composite walls in cold area

ON-SITE TESTING OF THERMAL PERFORMANCES OF AN AERIAL SLAB VENTILATED ROOF