Abstract:Commercially available gravimeters and seismometers can be used for measuring Earth's acceleration at resolution levels in the order of ng ∕ Hz (where g represents earth's gravity) but they are typically high-cost and bulky. In this work the design of a bulk micromachined MEMS device exploiting non-linear buckling behaviour is described, aiming for ng ∕ Hz resolution by maximising mechanical and capacitive sensitivity. High mechanical sensitivity is obtained through low structural stiffness. Near-zero stiffness is achieved through geometric design and large deformation into a region where the mechanism is statically balanced or neutrally stable. Moreover, the device has an integrated capacitive comb transducer and makes use of a high-resolution impedance readout ASIC. The sensitivity from displacement to a change in capacitance was maximised within the design and process boundaries given, by making use of a trench isolation technique and exploiting the large-displacement behaviour of the device. The measurement results demonstrate that the resonance frequency can be tuned from 8.7 Hz-18.7 Hz, depending on the process parameters and the tilt of the device. In this system, which combines an integrated capacitive transducer with a sensitivity of 2.55 aF/nm and an impedance readout chip, the theoretically achievable system resolution equals 17.02 ng ∕ Hz . The small size of the device and the use of integrated readout electronics allow for a wide range of practical applications for data collection aimed at the internet of things.

A Micromachined Gas Inertial Sensor Based on Thermal Expansion

A micromachined integrated gyroscope and accelerometer based on gas thermal expansion

Micromachined Gas Inertial Sensor Based on Convection Heat Transfer

Modeling And Experimental Study On Characterization Of Micromachined Thermal Gas Inertial Sensors

Sensor Fusion Methodology to Overcome Cross-Axis Problem for Micromachined Thermal Gas Inertial Sensor

A Study of Cross-axis Effect for Micromachined Thermal Gas Inertial Sensor

Design of Micromachined Thermal Expansion Gas Gyroscope Signal Detection Circuit

Micromachined Fluid Inertial Sensors

Experimental and Numerical Study of a Thermal Expansion Gyroscope for Different Gases

A Low-Power and Robust Micromachined Thermal Convective Accelerometer

Design of Digital Micromachined Thermal Gas Gyroscope

Analysis on Shock Resistance of Micromachined Angular Rate Sensor Based on Convection Heat Transfer

Design of Micro Inertial Measurement Unit Based on Micromachined Thermal Expansion Gas Gyroscope

A Continuous Dual-Axis Atomic Interferometric Inertial Sensor

A Novel Inertial Micro-Actuator and Its Application in Positioning Mechanism

A micromachined angular-acceleration sensor for geophysical applications

Toward High-Resolution Inertial Sensors Employing Parametric Modulation in Coupled Micromechanical Resonators

Design And Modeling Of Micromachined Thermal Convective Gyroscope With Bidirectional Jets

A chip-scale oscillation-mode optomechanical inertial sensor near the thermodynamical limits

Parametrically driven inertial sensing in chip-scale optomechanical cavities at the thermodynamical limits with extended dynamic range

High-resolution MEMS inertial sensor combining large-displacement buckling behaviour with integrated capacitive readout