Abstract:A micromachined electrostatically-suspended accelerometer (MESA) is a kind of three-axis inertial sensor based on fully-contactless electrostatic suspension of the proof mass (PM). It has the potential to offer broad bandwidth, high sensitivity, wide dynamic range and, thus, would be perfectly suited for land seismic acquisition. Previous experiments showed that it is hard to lift up the PM successfully during initial levitation as the mass needs to be levitated simultaneously in all six degrees of freedom (DoFs). By analyzing the coupling electrostatic forces and torques between three lateral axes, it is found there exists a self-locking zone due to the cross-axis coupling effect. To minimize the cross-axis coupling and solve the initial levitation problem, this paper proposes an effective control scheme by delaying the operation of one lateral actuator. The experimental result demonstrates that the PM can be levitated up with six-DoF suspension operation at any initial position. We also propose a feed-forward compensation approach to minimize the negative stiffness effect inherent in electrostatic suspension. The experiment results demonstrate that a more broadband linear amplitude-frequency response and higher suspension stiffness can be achieved, which is crucial to maintain high vector fidelity for potential use as a three-component MEMS geophone. The preliminary performance tests of the three-axis linear accelerometer were conducted under normal atmospheric pressure and room temperature. The main results and noise analysis are presented. It is shown that vacuum packaging of the MEMS sensor is essential to extend the bandwidth and lower the noise floor, especially for low-noise seismic data acquisition.

A micromachined angular-acceleration sensor for geophysical applications

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

A Compact Micromachined Interferometric Accelerometer Based on the Diffraction Grating

A MEMS-Based Electrochemical Angular Accelerometer With Integrated Plane Electrodes for Seismic Motion Monitoring

An Optical Interferometry Based MEMS Accelerometer Applicable to Seismic-Grade Measurement

A Sensitive Micromachined Resonant Accelerometer for Moving-Base Gravimetry

MEMS Microgravity Measurement Module with Nano-g/Hz Noise Floor for Spaceborne Higher-Level Microgravity Scientific Experiment Applications

High-resolution MEMS inertial sensor combining large-displacement buckling behaviour with integrated capacitive readout

A new electrochemical angular microaccelerometer with integrated sensitive electrodes perpendicular to flow channels

A MEMS Electrochemical Angular Accelerometer Leveraging Silicon-Based Three-Electrode Structure

MEMS surface microgravimetry for geotechnical surveying

A Seismic-Grade Optical MEMS Accelerometer with Force Feedback Control

High Sensitivity Optical MEMS Accelerometer Based on a Metal Fabry–Pérot Microcavities Wavelength Modulation System

A MEMS-based Electrochemical Angular Accelerometer based on Planar Electrodes with Micro-Pillar Array Structure

An Electrochemical Angular Micro-Accelerometer Based on Miniaturized Planar Electrodes Positioned in Parallel

A vibrating beam MEMS accelerometer for gravity and seismic measurements

A MEMS-Based Electrochemical Angular Accelerometer With a Force-Balanced Negative Feedback

A MEMS Electrochemical Angular Accelerometer with Silicon-Based Four-Electrode Structure

Self-Locking Avoidance and Stiffness Compensation of a Three-Axis Micromachined Electrostatically Suspended Accelerometer

A Sensitive Three-Axis Micromachined Accelerometer Based on an Electrostatically Suspended Proof Mass