Abstract:This paper presents an experimental and theoretical study of surface generation in the ultra-precision grinding of hard and brittle materials. The study takes into account the material properties, the relative vibration between the grinding wheel and the workpiece, the machining parameters and the phase shift of the grinding process. The Taguchi approach is employed to study the influence of machining parameters on the surface quality and shows that the feed speed and rotational speed of the workpiece are key factors. Experiments have been conducted to study individual variables, and the results further show that the feed rate and the cross-feed distance have a significant effect on surface generation. It is found that the spirals around the central area of the workpiece are the primary mechanism for surface generation, which originates from the synchronous relative tool-work vibration. The integral part of the ratio of the rotational speed of the grinding wheel to rotational speed of the workpiece determines the number of spirals and its fractional part controls the spiral geometry. A theoretical model for predicting the single spiral generation has been developed to explain the accumulation of the phase shift and the geometry. The changeable feed speed near the end of grinding is also modelled, revealing the approximate straight lines around one circle in the central region. The simulated results indicate that the theoretical models and the ground surfaces are in close agreement. The scallop-height model is developed to calculate the influence of phase shift on surface quality, and it is found that the phase shift near the medium value can effectively improve surface quality. Finally, a comparison of different surface generation mechanisms in grinding mould steel, tungsten carbide (WC) and reaction bonded silicon carbide (RB-SiC) is made. It is interesting to note that the Spanzipfel effect contributes to the surface generation not only on ductile materials such as mould steel but also on brittle materials such as WC and RB-SiC. The Spanzipfel effect is the most significant in grinding mould steel. For WC and RB-SiC, the ground surface contains both a ductile region and a brittle region in the form of micro-fractures.

Surface Generation Mechanism of Wc/Co and Rb-Sic/Si Composites under High Spindle Speed Grinding (Hssg)

A Study on Grinding Surface Waviness of Woven Ceramic Matrix Composites

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Some observations in grinding surface quality of FRCMC

Influence of diamond wheel grinding process on surface micro-topography and properties of SiO2/SiO2 composite

Wear-induced variation of surface roughness in grinding 2.5D C f /SiC composites

Investigation on the machined surface quality and removal mechanism of SiCf/SiC composites in ultrasonic-assisted grinding

Study on micro-grinding mechanism and surface quality of hardened 20 vol% SiCp/Al composites

An experimental and theoretical analysis of surface generation in the ultra-precision grinding of hard and brittle materials

Grinding Characteristics and Surface Roughness Modeling of 2.5D Woven SiCf/SiC Ceramic Matrix Composites

Investigation of grinding characteristics and removal mechanisms of 2D-C/SiC in high speed deep grinding

Mechanism analysis and process optimization of nanogrinding single-crystal SiC

Ductile-brittle transition mechanism of SiC particle-reinforced Al-MMCs under ultrasonic assisted grinding with single grain

Micro-removal mechanism of high volume fraction SiCp/Al composite in grinding based on cohesive theory

Investigation of the Machined Surface Integrity of WC-High-Entropy Alloy Cemented Carbide

Grindability and surface quality of SiCp/Al composites with resin bond and electroplated wheels

Experimental investigation on the problems in the achievement of super-smooth surface of cemented carbide WC-Co through diamond turning

Enhancing the grinding performance of RB-SiC ceramic using abrasive water jet dressed diamond grinding wheels

Grinding mechanism and surface quality evaluation strategy of single crystal 4H-SiC

Numerical simulation of single abrasive grain grinding of silicon carbide surface

Experimental study on grinding 2.5D C/SiC composites by electroplated grinding wheel with ordered abrasive clusters