Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

Effect of compound dimple on tribological performances of journal bearing

Study of offset factor and depths of dimple on the performance of two-lobe journal-bearings

Design and Fabrication of the Lubricating Dimple of the Headface Sliding Bearing with Phyllotactic Pattern

Investigation of the Effect of Milli-Scale Dimples on Planar Contact Lubrication

Effect of Micro-Dimple Geometry on the Tribological Characteristics of Textured Surfaces

Effect of Micro-Dimple Texture on the Tribological Performance of Brass with Titanium Nitride (TiN) Coating under Oil-Lubricated Conditions

Influence of Microdimple on Lubrication Performance of Textured Plunger Pump

Effect of Wide Dimples on Planar Contact Lubrication

Dynamic characteristics of compound textured journal bearing

Effects of Surface Waviness and Dimple on Elastohydrodynamic Lubrication

Simulation Study on Bearing Lubrication Mechanism and Friction Characteristics of the Biomimetic Non-Smooth Surface of a Cross-Scale, Second-Order Compound Microstructure

Study on the effects of the textured surface to improve the performance of cylinder block/valve plate interfaces

Effect of Compound Texture on Lubrication and Sealing Performance of Plunger Pump

Influence of Percolation effect of additives on the Performance of Conical Textured Porous Hybrid Journal Bearing

Effects of the array modes of laser-textured micro-dimples on the tribological performance of cylinder liner–piston ring

Effect of hollow-tube structure on the tribological performance of biomimetic water-lubricated bearing material

CFD Analysis of the Effect of Dimples and Cylinder Liner Honing Groove on the Tribological Characteristics of a Low Displacement Engine

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Effect of Micro-texture on Cavitation Distribution of Journal Bearing Friction Pair

Optimal design of micro-dimples on crankpin bearing surface for improving engine’s lubrication and friction

On the Tribological Characteristics of Dynamically Loaded Journal Bearing with Micropolar Fluids