Abstract:It has been recognized that purposefully designed surface texturing can contribute to the improvement of tribological performance of elements and friction reduction. However, its optimal parameters may depend on the operating conditions. This paper investigated the effect of a triangle-shaped dimples array on the tribological performance of the lubricated point-contacts under different lubrication regimes, based on the rotational sliding experiment of a patterned steel disk against smooth steel balls. The dimples arrays were produced by laser process and characterized by the 3D profilometer. A series of tests were conducted with different dimple parameters including depth, coverage ratio, size, and direction. Stribecklike curves were obtained to depict the transition of lubrication regimes, and the electrical contact resistance was utilized to qualitatively characterize the lubrication status. The test results showed that the dimples arrays with different sizes, depths and coverage ratios had a distinct effect on the friction behaviors. Compared with the nontextured surfaces, when the dimple depth decreased from 30μm to zero with fixed coverage ratio and size, the friction coefficient firstly decreased, and then increased. The friction coefficient finally approached that of the nontextured surface, during which the lowest value appeared at the dimple depth of approximately 10∼15μm. The coverage ratio of texture showed the similar effect on the friction coefficient. Usually, the coverage ratio of approximately 10% resulted in the lowest friction coefficient. The dimple size and direction also had obvious effects on the friction coefficient. Thus, it can be concluded that there exists a set of optimal values for the dimple depth, coverage ratio, size, and direction to realize the friction reduction.

Effect of Wide Dimples on Planar Contact Lubrication

Investigation of the Effect of Milli-Scale Dimples on Planar Contact Lubrication

Drag Reduction by Dimples on Surfaces in Plane–Plane Contact Lubrication

The Effect of Dimple Shapes on Friction of Parallel Surfaces

Effect of Micro-Dimples on Hydrodynamic Lubrication of Textured Sinusoidal Roughness Surfaces

Numerical and Experimental Investigation on Influence of Compound Dimple on Tribological Performances for Rough Parallel Surfaces

Geometric Shape Effects of Surface Texture on the Generation of Hydrodynamic Pressure Between Conformal Contacting Surfaces

Study on Effect of Dimples on Friction of Parallel Surfaces under Different Sliding Conditions

The Effect of Triangle-Shaped Surface Textures on the Performance of the Lubricated Point-Contacts

Theoretical Analysis on Hydrodynamic Lubrication of Cylinder Micro-dimple Surface Texture

Effects of Surface Waviness and Dimple on Elastohydrodynamic Lubrication

Influence of Microdimple on Lubrication Performance of Textured Plunger Pump

Hydrodynamic lubrication of microdimple textured surface using three-dimensional CFD

Friction Reduction Characteristics for Micro Dimples of Different Density

Study of the Friction and Wear of Dimple Textured Surfaces Based on Mixed Elastohydrodynamic Lubrication

Hydrodynamic Lubrication of Surfaces with Asymmetric Microdimple

Effect of Micro-Dimple Shapes on Tribological Properties of Specimen Surfaces

Numerical Study on Effect of Dimples on Tribo-Characteristics in Non-Newtonian Thermal Elastohydrodynamic Lubrication Point Contacts with Different Mechanical and Thermal Properties

Influence of a Surface Groove on the Lubricating Performance and Dimple Phenomena

Dimple Patterns Design for Different Circumstances

Effect of the Patterned Cylindrical Dimple Array on the Tribological Performance of Lubricated Point -Contacts