Abstract:With the development of surface precision machining technology and numerous studies on lubrication and friction reduction, the application of surface textures to achieve friction reduction has attracted extensive attention, but few studies have considered the influence of surface roughness on lubrication characteristics. By employing the computational fluid dynamics (CFD) simulation method, the lubrication models with rectangular textures and the introduction of rough asperity structures at the same time were established. The effects of the corresponding structure parameters on the lubrication performance of textured and roughed surfaces were studied under water lubrication conditions. Our results suggest that the adjustment of geometric parameters on the micro-/nano-structured surfaces could influence the bearing capacity of the water lubrication film, thus affecting the hydrodynamic lubrication performance on the surface. In addition, the generation of vortex in the micro-textures could bring changes in vorticity, which causes energy dissipation and affects frictional forces. In the lubrication model with rectangular textures, optimal hydrodynamic lubrication performance was obtained under the appropriate depth ratio at H=0.6. Meanwhile, the corresponding lubrication performance could be enhanced by increasing the width ratio (W) of surface textures. After introducing random asperity structures on the micro-textured surfaces with a standard deviation value of δ =0.5, the carrying capacity increased by 44%, and the friction coefficient decreased by 30.9%. Moreover, the introduction of half-sine rough asperity structures could only result in relatively minor differences in the lubrication performance, i.e., the changes in the bearing capacity and friction coefficient are less than 10%. However, the introduction of compound hierarchical structures consisting of random asperity structures and half-sine rough asperity structures could result in an increase in the corresponding bearing capacity by 42% and a reduction in friction coefficient (31.1%), which implies a significant enhancement in the hydrodynamic lubrication performance.

Friction Reduction Performance of Microstructured Surfaces Generated by Nonresonant Modulation Cutting

Numerical and Experimental Study of a Sector-Shaped Surface Texture in Friction Reduction

Investigation of the Effect of Milli-Scale Dimples on Planar Contact Lubrication

A Novel Surface Texture Shape for Directional Friction Control

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Surface Texturing for Low Friction Mechanical Components

Effect of Micro-Dimple Geometry on the Tribological Characteristics of Textured Surfaces

Generation method and antifriction performance evaluation of discrete micro-pit surface texture based on high speed ball-end milling process

Development of low-cost deformation-based micro surface texturing system for friction reduction

Laser Microtextured Surfaces for Friction Reduction: Does the Pattern Matter?

The Friction And Wear Behavior Of Laser Textured Surfaces In Non-Conformal Contact Under Starved Lubrication

Study on the Friction-Reducing Mechanisms of Surface Texture Cemented Carbide under Dry Sliding

Effect of Micro-Dimples on Hydrodynamic Lubrication of Textured Sinusoidal Roughness Surfaces

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Tribofilm Formation and Friction Reduction Performance on Laser-Textured Surface with Micro-Grooved Structures

Study on the effects of the textured surface to improve the performance of cylinder block/valve plate interfaces

Experimental Study on the Effect of Micro-Texture on EHL Point-Contact Film Thickness Subject to Sliding Conditions

Influence of Microdimple on Lubrication Performance of Textured Plunger Pump

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Fluid dynamics simulation on the water lubricating performance of surface micro-/nano-textured surfaces considering roughness structures

Study of the Effect of Transverse and Longitudinal Surface Patterns on Drag-Reduction in Shear-Thinning Fluid