Abstract:Buried pipelines need to withstand soil friction forces generated during relative movement between the soil and structure. The forces that develop along pipelines with diameter inconsistencies (i.e., with enlarged connections) are severely underestimated or ignored by current design practices. The movement of these enlarged connections can mobilize soil resistance similar to the response of vertical anchor plates. Previous centrifuge tests of vertical anchor plates have helped determine the soil's breakout capacity and mapped the failure planes for various anchor conditions. Although centrifuge testing allows large-scale geotechnical problems to be modeled and studied at a reduced-scale, practical limitations exist. In addition, rigid container boundaries are not present in situ and limit the soil's ability to develop its entire failure plane. Hence, experiments should be designed to reduce such boundary effects. An ideal test box is large enough to fully develop key failure planes in every direction. This paper determines the minimum boundary spacing necessary to adequately develop failure surfaces around a buried pipe. Centrifuge tests were conducted in samples of dense sand to determine how the distance to rigid container boundaries influences the force required to axially displace a pipe joint. Boundary influence was evident through a work-hardening response after the peak force, in which proximity to the boundary increased lateral force because of restricted volume expansion at the soil-container interface. The most influential parameter is experimentally shown as the distance from the pipe joint to the boundary parallel to the joint face in the direction of axial movement. The least significant parameter is the distance from the pipe to the rigid floor because a negligible quantity of soil is mobilized below the joint providing resistance. The results also provide insight into how rigid container boundaries are expected to impact the force-displacement response when minimum required dimensions are not achieved.

Centrifuge Testing to Simulate Buried Reinforced Concrete Pipe Joints Subjected to Traffic Loading

CENTRIFUGE MODELING OF LARGE DIAMETER UNDERGROUND PIPES SUBJECTED TO HEAVY TRAFFIC LOADS

A Simplified Analytical Solution of Pipeline Response under Normal Faulting

Elasto-plastic Solution for Tunnelling-Induced Nonlinear Responses of Overlying Jointed Pipelines in Sand

The Longitudinal Response of Buried Large-Diameter Reinforced Concrete Pipeline with Gasketed Bell-and-spigot Joints Subjected to Traffic Loading

The Behaviour of Jointed Large-Diameter Reinforced Concrete Pipeline Buried in Various Ground Conditions

Influence of Erosion Voids and Traffic Loads on Buried Large-Diameter Reinforced Concrete Pipes

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Uplift tests and uplift resistance analysis of pipe segment in soft backfill clay

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Uplifting Behavior of Shallow Buried Pipe in Liquefiable Soil by Dynamic Centrifuge Test

Centrifuge Model Design for Axially Loaded Structures under Large Ground Movements

Road Surface Permanent Deformations with a Shallowly Buried Steel-Reinforced High-Density Polyethylene Pipe under Cyclic Loading

Centrifuge Modeling of a Saturated Clay Ground under Cyclic Loading

The Influence of Erosion Voids on the Longitudinal Behaviour of a Jointed Large-Diameter Reinforced Concrete Pipeline

Site-based Experimental Study on Pipe Behavior During Pipe Jacking

Application of Particle Image Velocimetry (PIV) in the Study of Uplift Mechanisms of Pipe Buried in Medium Dense Sand

ANALYSIS OF STABILITY FAILURE FOR PIPELINE DURING LONG DISTANCE PIPE JACKING

Mechanistic-Empirical Model to Characterize Rutting in Unpaved Road with a Shallowly Buried SRHDPE Pipe

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment