Abstract:Permanent deformation is a long-term irrecoverable depression accumulated in the wheel path when the flexible pavement is subjected to heavy loads at high temperature, which can be simulated using the vertically loaded wheel test (VLWT) in the laboratory. The objective of this study is to develop a new approach to analyze the vertically loaded wheel test results based on the elastic-viscoelastic correspondence principle. The energy-based pseudo variables are proposed to perform rutting evaluation of asphalt mixtures in the VLWT.Four types of styrene-butadienestyrene modified asphalt mixtures were prepared to conduct the undamaged compressive dynamic modulus test at different temperatures. Then the master curves of dynamic modulus for these mixtures were converted to get the relaxation modulus. The innovative VLWT for four types of two-layer structure with different asphalt mixture combinations were performed to investigate the rutting development. After that, a new mechanical-empirical rutting prediction model was introduced to predict the rutting development for each layer in the two-layer structure. The energy-based pseudo variables including pseudo strain, pseudo strain rate and dissipated pseudo strain energy (DPSE) were introduced to correlate with the rutting resistance.The results show that the developed mechanical-empirical rutting prediction model is proficient in capturing the rutting development of a two-layer structure of asphalt mixtures measured by a vertically loaded wheel tester. The rutting contributions of the top and bottom layers can be separated using this model. Compared with the total strain, the pseudo strain which removes the viscoelastic effect, is more accurate to evaluate the permanent deformation in a cyclic loading condition. The DPSE increases with the increase of loading cycles and rut depth. Two typical stages with an inflection point can be observed from the test results which indicate that the faster to reach the inflection point, the better rutting performance will be achieved.

Road Surface Permanent Deformations with a Shallowly Buried Steel-Reinforced High-Density Polyethylene Pipe under Cyclic Loading

Mechanistic-Empirical Model to Characterize Rutting in Unpaved Road with a Shallowly Buried SRHDPE Pipe

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Evaluation of Rutting Potential of Flexible Pavement Structures Using Energy-Based Pseudo Variables

A Combined Method to Predict the Long-Term Settlements of Roads on Soft Soil under Cyclic Traffic Loadings

Dynamic Response Analysis of Buried HDPE Pipes under Vibration Compaction Considering the Influence of Buried Depth and Filling Modulus

Analysis of Effect of Ground Deformation on Buried Pipe

Investigating the Deformation Characteristics of Buried High-Density Polyethylene Pipes: Considering the Effect of Sequentially Applying Pressure and Elevating Temperature

Experimental Study on Uplift Mechanisms of Pipes Buried in Sloping Medium Dense Sand

Application of Particle Image Velocimetry (PIV) in the Study of Uplift Mechanisms of Pipe Buried in Medium Dense Sand

Undrained Behaviour of Intact Soft Clay under Cyclic Paths That Match Vehicle Loading Conditions

Uplifting Behavior of Shallow Buried Pipe in Liquefiable Soil by Dynamic Centrifuge Test

Analytical Solution for Upheaval Buckling of Shallow Buried Pipelines in Inclined Cohesionless Soil

Studies on Bearing Characteristic of Open-Ended and Close-Ended Pipe Piles under High-Speed Railway Loadings

A Constitutive Model for the Accumulated Strain of Unsaturated Soil under High‐cycle Traffic Loading

Analytical Analysis of Pipeline–soil Interaction During J-lay on a Plastic Seabed with Bearing Resistance Proportional to Depth

Field investigation on structural performance of the buried UPVC pipes with and without geogrid reinforcement

Predicting Postconstruction Settlements Generated by Moving Traffic on Highways Built on Soft Soil in China Using Mechanistic-Empirical Design Method

Centrifuge Testing to Simulate Buried Reinforced Concrete Pipe Joints Subjected to Traffic Loading

Quantitative Assessment of Damage in Buried Polyethylene Pipe Subjected to Land Subsidence

Effects of Corrugated Steel Pipe Parameters on the Stress and Deformation of a Highway Subgrade Culvert