Abstract:<p>The thermodynamic performance of a High‐Temperature Heat Pump Steam (HTHPS) system is determined mainly by its different cycle configurations. The present study involved improving the thermodynamic performance of a quasi‐two‐stage vapor compression high‐temperature heat pump based on a front internal heat exchanger (IHX) and rear internal heat exchanger cycle, and analyzing the influence of an internal heat exchanger. The present study established thermodynamic models for Front Reheating Structure (FRS) and Rear Reheating Structure (RRS) models on the basis of conservation of mass and energy. The system was compared to the traditional TF quasi‐two‐stage compression cycle system in terms of thermodynamic parameters. The results demonstrated that the thermodynamic performance of RRS was optimized under the same conditions. The RRS system exhibited an increase of 4.87% in the COP when the exhaust superheats is maintained are under 5K. Moreover, with an increase in the condensation temperature, the required mass flow of the refrigerant in the traditional system was 9.94%–12.36% higher compared to the RRS system, the power consumption of the compressor was increased by 3.9%–5.6%, and the steam output per unit refrigerant was decreased by 1.04%–5.07%. Furthermore, the Aspen Plus simulation verified that the reason for the change in the exhaust superheats was the different pressure ratios in the theoretical calculation, which is more practical.</p><p>This article is protected by copyright. All rights reserved.</p>

Theoretical Analysis on Optimal Configurations of Heat Exchanger and Compressor in a Two-Stage Compression Air Source Heat Pump System

Theoretical Analyses of a New Two-Stage Absorption-Transcritical Hybrid Refrigeration System

Thermodynamic Analysis on a Two-Stage Transcritical CO2 Heat Pump Cycle with Double Ejectors

Simulation and Optimum Control of a Two-Stage Compression Air Source Heat Pump System: A Comparison of Two Kinds of Variable Volume Approaches

Optimum Compressor Cylinder Volume Ratio for Two-Stage Compression Air Source Heat Pump Systems.

Heating performance optimization of a two-stage compression air source heat pump based on simulation

Theoretical Analysis of a Novel Two-Stage Compression System Using Refrigerant Mixtures

Further Analysis of the Influence of Interstage Configurations on Two-Stage Vapor Compression Heat Pump Systems

An optimal design method for a heat exchanger for a dual-stage circulating high-temperature heat pump system

Simulation on a Two-Stage Compression Heat Pump with Focus on Optimum Control

Experimental study on two-stage compression refrigeration/heat pump system with dual-cylinder rolling piston compressor

Optimization of heat exchanger type for two-stage compression high temperature heat pumps

DEVELOPMENT AND EXPERIMENTAL INVESTIGATION ON TWO-STAGE COMPRESSION VARIABLE FREQUENCY AIR SOURCE HEAT PUMP

Performance Analysis of Internal Heat Exchanger‐Based Quasi‐Two‐Stage Vapor Compression Heat Pump System for High‐Temperature Steam Production

Finite-time Thermodynamic Analysis of a Two-Stage Combined Heat Pump System

Theoretical Analysis on a Novel Two-Stage Compression Transcritical CO2 Dual-Evaporator Refrigeration Cycle with an Ejector

A general model for two-stage vapor compression heat pump systems

Optimal design for dual-stage high temperature heat pump by heat exchange area simulation

Research on a new two-stage compression for heat pump air-conditioning with R32

Energy and Exergy Analysis of Various Ejector-Assisted Two-Stage Compression Heat Pumps Applied in Various Conditions

Performance Analysis of a Refrigerant Extracting Twin Screw Compressor Employed in Multi-Temperature Heat Pump Systems