Abstract:The effect of carbon content on the corrosion resistance of Ni-Co-Cr-Mo-Cu alloys in H2SO4 2 SO 4 and HCl was investigated through electrochemical and immersion tests in H2SO4 2 SO 4 and HCl. The alloys containing 0.2-2 wt% C which were produced using hot isostatic pressing. The electrochemical corrosion results show that with the increase of C content, the equivalent impedance of the four alloys in H2SO4 2 SO 4 and HCl aqueous solutions decreases, and the corrosion resistance decreases. The immersion corrosion results show that the corrosion resistance of the four alloys in H2SO4 2 SO 4 aqueous solution is not significantly correlated with the C content, and all exhibit extremely strong corrosion resistance. The passivation film is mainly composed of the inner layer of Cr2O3, 2 O 3 , the metallic Mo, MoO32- 3 2- and MoO42- 4 2- ions in the middle layer, and the outer layer of metallic Cu. The alloy with a C content of 1.5 and 2 wt% undergoes matrix corrosion in HCl aqueous solution with corrosion rates of 17.5 and 35.0 x 10-3-3 mg/ (cm2 & sdot;h). 2 & sdot;h). Due to the excessive precipitation of carbides, the insufficient Mo content in the alloy matrix and the instability of metallic Cu in HCl aqueous solution result in the transformation of some inner layer Cr2O3 2 O 3 passivation films into Cr(OH)3, 3 , leading to a decrease in the corrosion resistance of high C alloys.

Corrosion Resistance of Cu- and Fe-modified Ni–30Co–16Cr–15Mo Alloy in Aqueous Hydrofluoric Acid

Influence of Ni Addition on Corrosion Performance of Medium-temperature Filler Metal with Low Cu Content for Al Brazed Joints

Influence of Cu Addition on Corrosion Behavior and Tensile Performance of Ni-30Co-16Cr-15Mo-6Fe Alloy

Effects of Partially Substituting Cobalt for Nickel on the Corrosion Resistance of a Ni–16Cr–15Mo Alloy to Aqueous Hydrofluoric Acid

Regulating the passive film of NiCoCrMo alloy in hydrofluoric acid solution by small addition of Cu

Influence of Mo concentration on corrosion resistance to HF acid solution of Ni–Co–Cr–Mo alloys with and without Cu

Roles of Mo and Cu on Electrochemical Behaviors of Ni-Base Alloys in Hydrofluoric Acid Solution

Corrosion Behaviours of Low Mo Ni-(Co)-Cr-Mo Alloys with Various Contents of Co in HF Acid Solution

Effect of Heat Treatment on the Highly Corrosion-Resistant Cu70ni27.7fe2.3 Alloy

Effects of cold working on corrosion resistance of Co-modified Ni–16Cr–15Mo alloy in hydrofluoric acid solution

Effect of Cu on the Corrosion Resistance and Electrochemical Response of a Ni–Co–Cr–Mo Alloy in Acidic Chloride Solution

Ex-situ Observation on the Dissolution Behaviour of Ni–16Cr–15Mo and Ni–30Co–16Cr–15Mo Alloys in Hydrofluoric Acid

Effect of alloying elements (Mn, Ti, and Mo) on the corrosion behavior of FeCoNiCr-based high entropy alloy in supercritical water

Effects of elemental composition and microstructure inhomogeneity on the corrosion behavior of nickel-based alloys in hydrofluoric acid solution

Effect of Cr Addition on Corrosion Behavior of Cupronickel Alloy in 3.5 Wt% NaCl Solution

Effect of Carbon Content on the Corrosion Behavior of Ni-Co-Cr-Mo-Cu Alloys in Both Sulfuric and Hydrochloric Acids

The Corrosion Behavior of Sintering Micro-Porous Ni–Cu Alloy in Hydrofluoric Acid Solution

Enhancement of Corrosion Resistance of Fe–Cr–Mo Alloy to Molten Al by Thermal Oxidation in Air

Corrosion Performance of a High-Strength FeNiCrAl Medium-Entropy Alloy Compared with 304 Stainless Steel in KOH Solution

Effects of Cu Addition on the Corrosion Behavior of NiCoCrMo Alloys in Neutral Chloride Solution

Corrosion Behavior of Cu-Ni-Fe-Mn-Cr Alloy in 3.5 Wt.% NaCl Solution