Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Effect Of Humidified Water Vapor On Heat Balance Management In A Proton Exchange Membrane Fuel Cell Stack

Numerical Analysis of Static and Dynamic Heat Transfer Behaviors Inside Proton Exchange Membrane Fuel Cell

A single-phase, non-isothermal model for PEM fuel cells

Investigation of Water and Heat Transfer Mechanism in PEMFCs Based on a Two-Phase Non-Isothermal Model

Investigation of the Temperature-Related Performance of Proton Exchange Membrane Fuel Cell Stacks in the Presence of CO

Effect of Inner Dehumidification Technique on the Performance of a Dead‐ended Proton Exchange Membrane Fuel Cell Stack

Water Management in a Novel Proton Exchange Membrane Fuel Cell Stack with Moisture Coil Cooling

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

Moisture Dehumidification and Its Application to a 3 Kw Proton Exchange Membrane Fuel Cell Stack

Optimizing the Relative Humidity to Improve the Stability of a Proton Exchange Membrane by Segmented Fuel Cell Technology

Effect of Cathode Moisture Condensation on Temperature Distribution Characteristics of Dead‐ended Proton‐exchange Membrane Fuel Cell Stack

Thermal Analysis and Management of Proton Exchange Membrane Fuel Cell Stacks for Automotive Vehicle

Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

A Breakthrough Performance Improvement in a Proton Exchange Membrane Fuel Cell Stack by Moisture Coil Cooling

Thermal Management of Open-Cathode Proton Exchange Membrane Fuel Cell Stack with Thin Vapor Chambers

The Use of Phase-Change Cooling Strategy in Proton Exchange Membrane Fuel Cells: A Numerical Study

3D multi-phase simulation of metal bipolar plate proton exchange membrane fuel cell stack with cooling flow field

Numerical and Experimental Investigation of the Asymmetric Humidification and Dynamic Temperature in Proton Exchange Membrane Fuel Cell

Control-oriented Modeling and Exploration of Hygrothermal Characteristics of Air-Cooled Proton Exchange Membrane Fuel Cell