Abstract:As a promising new power source, the proton exchange membrane fuel cell (PEMFC) has attracted extensive attention. The PEMFC engine produces a large amount of waste heat during operation. The excessive temperature will reduce the efficiency and lifespan of PEMFC engine and even cause irreversible damage if not taken away in time. The thermal management system of the PEMFC plays a critical role in efficiency optimization, longevity and operational safety. To solve the problem of high heat production in the operation of the PEMFC, two approaches are proposed to improve the heat dissipation performance of the radiators in thermal management systems. Three kinds of nanofluids with excellent electrical and thermal conductivity–Al2O3, SiO2 and ZnO– are employed as the cooling medium. The radiator parameters are optimized to improve the heat transfer capability. A typical 1D thermal management system and an isotropic 3D porous medium model replacing the wavy fin are constructed to reveal the effects of the nanofluid and the parameters of the radiator performance and the thermal management system. The results show that all three kinds of nanofluids can effectively improve the heat transfer capacity of the coolant, among which the comprehensive performance of the Al2O3 nanofluid is best. When the mass flow rate is 0.04 kg/s and the concentration is 0.5 vol%, the amount of heat transfer of the Al2O3 nanofluid increases by 12.7% when compared with pure water. Under the same conditions, it can reduce the frontal area of the radiator by 12%. For the radiator, appropriate reduction of the fin pitch and wavy length and increase of wave amplitude can effectively improve the spread of heat. The use of fin parameters with higher heat dissipation power results in lower coolant temperatures at the inlet and outlet of the stack. The performance of the radiator is predicted by the two model-based approaches described above which provide a reliable theoretical basis for the optimization of the thermal management system and the matching of the components.

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

A Two-Dimensional Analysis of Mass Transport in Proton Exchange Membrane Fuel Cells

Influence of Heat Transfer on Gas and Water Transport in Fuel Cells

A single-phase, non-isothermal model for PEM fuel cells

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

Analyzing Key Factors Influencing Water Transport in Open Air-Cooled PEM Fuel Cells

Thermal management system modeling of a water-cooled proton exchange membrane fuel cell

Analytical Calculation and Evaluation of Water Transport Through a Proton Exchange Membrane Fuel Cell Based on a One-Dimensional Model

Modeling and analysis of water vapor dynamics in high-temperature proton exchange membrane fuel cell coupling gas-crossover phenomena

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

A model predicting performance of proton exchange membrane fuel cell stack thermal systems

Recent advances in heat and water management of forced-convection open-cathode proton exchange membrane fuel cells

A Closed-Loop Water Management Methodology for PEM Fuel Cell System Based on Impedance Information Feedback

Modelling of Humidity Dynamics for Open-Cathode Proton Exchange Membrane Fuel Cell

Model-Based Performance Optimization of Thermal Management System of Proton Exchange Membrane Fuel Cell

Simulation of Water Transport in Proton Exchange Membrane Fuel Cell Using a One-dimension Model

Numerical Simulation of Three-Dimensional Gas/liquid Two-Phase Flow in a Proton Exchange Membrane Fuel Cell

Modeling and analysis of internal water transfer behavior of PEM fuel cell of large surface area

Thermal management for an air coolant system of a proton exchange membrane fuel cell using heat distribution optimization

A two-phase flow and non-isothermal agglomerate model for a proton exchange membrane (PEM) fuel cell

A 3D, Multiphase, Multicomponent Model of the Cathode and Anode of a PEM Fuel Cell