Abstract:As a promising new power source, the proton exchange membrane fuel cell (PEMFC) has attracted extensive attention. The PEMFC engine produces a large amount of waste heat during operation. The excessive temperature will reduce the efficiency and lifespan of PEMFC engine and even cause irreversible damage if not taken away in time. The thermal management system of the PEMFC plays a critical role in efficiency optimization, longevity and operational safety. To solve the problem of high heat production in the operation of the PEMFC, two approaches are proposed to improve the heat dissipation performance of the radiators in thermal management systems. Three kinds of nanofluids with excellent electrical and thermal conductivity–Al2O3, SiO2 and ZnO– are employed as the cooling medium. The radiator parameters are optimized to improve the heat transfer capability. A typical 1D thermal management system and an isotropic 3D porous medium model replacing the wavy fin are constructed to reveal the effects of the nanofluid and the parameters of the radiator performance and the thermal management system. The results show that all three kinds of nanofluids can effectively improve the heat transfer capacity of the coolant, among which the comprehensive performance of the Al2O3 nanofluid is best. When the mass flow rate is 0.04 kg/s and the concentration is 0.5 vol%, the amount of heat transfer of the Al2O3 nanofluid increases by 12.7% when compared with pure water. Under the same conditions, it can reduce the frontal area of the radiator by 12%. For the radiator, appropriate reduction of the fin pitch and wavy length and increase of wave amplitude can effectively improve the spread of heat. The use of fin parameters with higher heat dissipation power results in lower coolant temperatures at the inlet and outlet of the stack. The performance of the radiator is predicted by the two model-based approaches described above which provide a reliable theoretical basis for the optimization of the thermal management system and the matching of the components.

Thermal management system modeling of a water-cooled proton exchange membrane fuel cell

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Research on Control Algorithm of Proton Exchange Membrane Fuel Cell Cooling System

A single-phase, non-isothermal model for PEM fuel cells

Numerical Analysis of Static and Dynamic Heat Transfer Behaviors Inside Proton Exchange Membrane Fuel Cell

Modelling and Simulation System of Proton Exchange Membrane Fuel Cell

Investigation of Water and Heat Transfer Mechanism in PEMFCs Based on a Two-Phase Non-Isothermal Model

MPC-based thermal management for water-cooled proton exchange membrane fuel cells

Optimal design of thermostat for proton exchange membrane fuel cell cooling system

Model-Based Performance Optimization of Thermal Management System of Proton Exchange Membrane Fuel Cell

Study of Thermal Management in Water-Cooled PEMFC

One-Dimensional Simulation Design and Prediction of Thermostat in PEMFC Fuel Cell System

Coolant Circuit Modeling and Temperature Fuzzy Control of Proton Exchange Membrane Fuel Cells

Thermal management for proton exchange membrane fuel cells

System-level modeling of proton exchange membrane fuel cell

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

Active Thermal Management for an Automotive Water-Cooled Proton Exchange Membrane Fuel Cell by Using Feedback Control

Thermal management for an air coolant system of a proton exchange membrane fuel cell using heat distribution optimization

Thermal Analysis and Management of Proton Exchange Membrane Fuel Cell Stacks for Automotive Vehicle

Thermal Management System Modeling and Simulation of a Full-Powered Fuel Cell Vehicle

A model predicting performance of proton exchange membrane fuel cell stack thermal systems