Abstract:As a promising new power source, the proton exchange membrane fuel cell (PEMFC) has attracted extensive attention. The PEMFC engine produces a large amount of waste heat during operation. The excessive temperature will reduce the efficiency and lifespan of PEMFC engine and even cause irreversible damage if not taken away in time. The thermal management system of the PEMFC plays a critical role in efficiency optimization, longevity and operational safety. To solve the problem of high heat production in the operation of the PEMFC, two approaches are proposed to improve the heat dissipation performance of the radiators in thermal management systems. Three kinds of nanofluids with excellent electrical and thermal conductivity–Al2O3, SiO2 and ZnO– are employed as the cooling medium. The radiator parameters are optimized to improve the heat transfer capability. A typical 1D thermal management system and an isotropic 3D porous medium model replacing the wavy fin are constructed to reveal the effects of the nanofluid and the parameters of the radiator performance and the thermal management system. The results show that all three kinds of nanofluids can effectively improve the heat transfer capacity of the coolant, among which the comprehensive performance of the Al2O3 nanofluid is best. When the mass flow rate is 0.04 kg/s and the concentration is 0.5 vol%, the amount of heat transfer of the Al2O3 nanofluid increases by 12.7% when compared with pure water. Under the same conditions, it can reduce the frontal area of the radiator by 12%. For the radiator, appropriate reduction of the fin pitch and wavy length and increase of wave amplitude can effectively improve the spread of heat. The use of fin parameters with higher heat dissipation power results in lower coolant temperatures at the inlet and outlet of the stack. The performance of the radiator is predicted by the two model-based approaches described above which provide a reliable theoretical basis for the optimization of the thermal management system and the matching of the components.

Research on Thermal Management System of Fuel Cell Engine for Vehicle

A model predicting performance of proton exchange membrane fuel cell stack thermal systems

Modeling and simulation of vehicle integrated thermal management system for a fuel cell hybrid vehicle

A single-phase, non-isothermal model for PEM fuel cells

Thermal Management System Modeling and Simulation of a Full-Powered Fuel Cell Vehicle

Thermal management system modeling of a water-cooled proton exchange membrane fuel cell

Model-Based Performance Optimization of Thermal Management System of Proton Exchange Membrane Fuel Cell

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

Design and optimization of thermal strategy to improve the thermal management of proton exchange membrane fuel cells

Thermal Management Subsystem Model and Temperature Control for Fuel Cells

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

Thermal management for an air coolant system of a proton exchange membrane fuel cell using heat distribution optimization

Performance prediction of proton exchange membrane fuel cell engine thermal management system using 1D and 3D integrating numerical simulation

Thermal characteristics of an air‐cooled open‐cathode proton exchange membrane fuel cell stack via numerical investigation

Thermal management using phase change materials for proton exchange membrane fuel cells

Performance evaluation on thermodynamics-economy-environment of PEMFC vehicle power system under dynamic condition

A Review of Thermal Management of Proton Exchange Membrane Fuel Cell Systems

Conventional and advanced exergy analyses of a vehicular proton exchange membrane fuel cell power system

Graphical Thermal Model of Proton Exchange Membrane Fuel Cell System Based on Energetic Macroscopic Representation

Dynamic cross-scale modeling and thermo-electric response characteristics of PEMFC based on standardized thermal resistance

Model-based decoupling control for the thermal management system of proton exchange membrane fuel cells