Abstract:A proton exchange membrane (PEM) fuel cell is one of the highly efficient hydrogen utilization devices. However, due to the complex physical and chemical processes in fuel cells, developing a mathematical model of the PEM fuel cell is challenging. In this study, a new coupled model based on the computational fluid dynamics method and a 1D model is proposed for the accurate and fast prediction of PEM fuel cell performance. First of all, the proposed model is validated using the literature data. It is then applied to simulate the distribution and evolution of the current density, hydrogen and oxygen mass fraction, and membrane water content in catalyst layer (CL). Results show that the increase in the current density is attributed to the increase in the consumption rate of hydrogen and oxygen and the increase in the membrane water content. In addition, the stabilized supply of the oxygen in cathode and the membrane water content in the anode CL are critical for the improvement of the fuel cell performance. For the cases studied in this research, when the output voltage decreases from 0.6 V to 0.3 V, the current density increases from 5738.1 A/m2 to 15171.2 A/m2. The average oxygen mass fraction in the cathode CL and the average membrane water content in the anode CL decreased by 42.3 % and 9.6 %, respectively. In addition, when the fuel cell starts up at 0.6 V, the concentration of hydrogen and oxygen drops gradually decreases along the flow direction of the CL, while the membrane water content rapidly increases initially, and then increases slowly, with the turning point around at approximately 2.2 x 10-3 m. Under the combined effect of hydrogen and oxygen concentration, as well as the membrane water content, the current density first increases and then decreases, with the maximum value exceeding 6500 A/m2.

Simulation of Water Transport in Proton Exchange Membrane Fuel Cell Using a One-dimension Model

A Two-Dimensional Analysis of Mass Transport in Proton Exchange Membrane Fuel Cells

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Analytical Calculation and Evaluation of Water Transport Through a Proton Exchange Membrane Fuel Cell Based on a One-Dimensional Model

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

A 1 + 1-D Multiphase Proton Exchange Membrane Fuel Cell Model for Real-Time Simulation

Investigation of Water and Heat Transfer Mechanism in PEMFCs Based on a Two-Phase Non-Isothermal Model

Simulation of PEM Fuel Cells Using the Mixed-domain Model

Numerical Simulation of Water Transport in a Proton Exchange Membrane Fuel Cell Flow Channel

Disclosure of the Internal Transport Phenomena in an Air-Cooled Proton Exchange Membrane Fuel Cell-Part I: Model Development and Base Case Study

Large-scale three-dimensional simulation of proton exchange membrane fuel cell considering detailed water transition mechanism

Numerical Modeling and Performance Prediction of Water Transport for PEM Fuel Cell

A Control-Oriented Model for Predicting Variations in Membrane Water Content of an Open-Cathode Proton Exchange Membrane Fuel Cell

Three-dimensional two-phase flow model of proton exchange membrane fuel cell with parallel gas distributors

A Coupled CFD Model for an Accurate and Fast Prediction of the Unsteady Operation Process of a Proton Exchange Membrane Fuel Cell

Non-isothermal One-Dimensional Two-Phase Model of Water Transport in Proton Exchange Membrane Fuel Cells with Micro-porous Layer

Numerical Simulation of Anti-flooding Electrode Proton Exchange Membrane Fuel Cell

A Three-Dimensional, Multicomponent, Two-Phase Model For A Proton Exchange Membrane Fuel Cell With Straight Channels

Simulation of the Internal Transport Phenomena for Pem Fuel Cells with Different Modes of Flow

Modelling of Humidity Dynamics for Open-Cathode Proton Exchange Membrane Fuel Cell

Illustrative Case Study on the Performance and Optimization of Proton Exchange Membrane Fuel Cell