Abstract:Humidification is one of the most important factors for the state-of-the-art Proton Exchange Membrane Fuel Cell (PEMFC) to maintain high water content in the electrolyte and to ensure reasonable ionic conductivity. However, liquid water may generate when the partial pressure of the water vapor reaches to its saturated point during operation, which can cause water flooding to the electrode and lead to poor performance of the PEMFC, especially at high current density. Moisture dehumidification is introduced to help remove the excessive water inside a 3 kW PEMFC stack in this paper. A radiator is set at the outlet of the stack to cool the moisture of the cathode. Thus, liquid water is condensed from the moisture due to the variation of the saturated pressure of water vapor, which can accelerate the evaporating of the liquid water inside the stack and mitigate the probability of flooding in the membrane electrode assembly (MEA). The stack with a radiator at the outlet of the cathode is fabricated to systematically investigate the effects of the stack temperature, air relative humidity, and operating pressure on the stack performance. The results show that with the help of moisture condensation, water removal ability is improved inside the stack. With the introduction of moisture dehumidification, 13% of increase in stack performance at 1.0 A cm(-2) is observed compared with the stack performance without moisture dehumidification. Copyright (C) 2014, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Water Management in a Novel Proton Exchange Membrane Fuel Cell Stack with Moisture Coil Cooling

A Breakthrough Performance Improvement in a Proton Exchange Membrane Fuel Cell Stack by Moisture Coil Cooling

Moisture Dehumidification and Its Application to a 3 Kw Proton Exchange Membrane Fuel Cell Stack

Effect of Inner Dehumidification Technique on the Performance of a Dead‐ended Proton Exchange Membrane Fuel Cell Stack

Effects of Moisture Dehumidification on the Performance and Degradation of a Proton Exchange Membrane Fuel Cell

Self-Water-Removal and Voltage Behavior Improvement of Dead-Ended Proton Exchange Membrane Fuel Cell Stack at Steady-State and Dynamic Conditions

Effect Of Humidified Water Vapor On Heat Balance Management In A Proton Exchange Membrane Fuel Cell Stack

Effect of Cathode Moisture Condensation on Temperature Distribution Characteristics of Dead‐ended Proton‐exchange Membrane Fuel Cell Stack

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Investigation of the Temperature-Related Performance of Proton Exchange Membrane Fuel Cell Stacks in the Presence of CO

Experimental Study on the Effect of Flow Channel Parameters on the Durability of PEMFC Stack and Analysis of Hydrogen Crossover Mechanism

Experimental study on improving the dynamic characteristics of open-cathode PEMFC stack with dead-end anode by condensation and circulation of hydrogen

Interfacial Water Management of Gradient Microporous Layer for Self-Humidifying Proton Exchange Membrane Fuel Cells

Investigation of Water and Heat Transfer Mechanism in PEMFCs Based on a Two-Phase Non-Isothermal Model

Analysis of Water Management in Proton Exchange Membrane Fuel Cells

Recent advances in heat and water management of forced-convection open-cathode proton exchange membrane fuel cells

Water Recovery and Air Humidification by Condensing the Moisture in the Outlet Gas of a Proton Exchange Membrane Fuel Cell Stack

Comparison of Lifetime Performance of Pemfc Stacks with Two Cooling Strategies under Different Humidity

Proton Exchange Membrane Fuel Cell with Humidifying Zone

Design of an Air Humidifier for a 5 Kw Proton Exchange Membrane Fuel Cell Stack Operated at Elevated Temperatures

In-Situ Measurement of Humidity Distribution and Its Effect on the Performance of a Proton Exchange Membrane Fuel Cell