Abstract:Purification section of syngas from coal is located after water gas shift to remove hydrogen sulfide, carbon dioxide as the main gas impurities and obtain high purity hydrogen. At present, the mature purification processes include wet method represented by low temperature methanol scrubbing and liquid nitrogen scrubbing, and dry method represented by pressure swing adsorption decarburization. The operating temperature of the elevated temperature pressure swing adsorption technology proposed is consistent with the temperature of the incoming shift gas. Self-made hydrophobic nitrogen-rich activated carbon adsorbent was deployed to achieve desulfurization and carburization by increasing the traditional pressure swing adsorption operating temperature to 170-220 ℃ and high humidity environment. Two new PSA steps, high pressure steam rinse and low pressure nitrogen purge, were adopted to improve H 2 recovery to above 99%. The elevated temperature pressure swing adsorption H 2 /CO 2 separation demonstration with a processing capacity of 5 000 m~3/h（standard condition）was built and operated using coal based shift gas from Quanji Plant as the feedstock for the pilot plant. The purity of hydrogen reaches the hydrogen fuel level（including N 2 ） through two-stage ETPSA, and the pilot plant has been running for more than 2 800 hours in total. In addition, the energy consumption of the pilot plant was calculated based on the utilities expenses. When taking power consumption into consideration, the operation cost of H 2 purification for the pilot test can be significantly reduced by about 35% compared with the power consumption of H 2 purification by low temperature methanol scrubbing at Fengxi Plant. This technology breaks through the limitation of temperature of conventional adsorption and purification for solid adsorbents, and realizes directional removal of impurities in hydrogen by using adsorbents with preferred selective adsorption performance at elevated temperature, which confirms a new process route for efficient and high-quality hydrogen purification.

Techno-economic Evaluation of an Elevated Temperature Pressure Swing Adsorption Process in A 540 MW IGCC Power Plant with CO2 Capture

Integrated Gasification Combined Cycle with Carbon Dioxide Capture by Elevated Temperature Pressure Swing Adsorption

Performance Exploration of Temperature Swing Adsorption Technology for Carbon Dioxide Capture

Mechanism Modeling of Elevated Temperature Pressure Swing Adsorption Process for Pre-Combustion Co2 Capture

Efficiency Analysis of Warm Gas Clean up in Integrated Gasification Fuel Cell (IGFC) System

Thermodynamic Exploration of Two-Stage Vacuum-Pressure Swing Adsorption for Carbon Dioxide Capture

Analysis on Temperature Vacuum Swing Adsorption Integrated with Heat Pump for Efficient Carbon Capture

Influences Of Co2 Capture On Coal Water Slurry Igcc Performance

Elevated Temperature Pressure Swing Adsorption Process for Reactive Separation of CO/CO2 in H2-rich Gas

Analyses of hot/warm CO2 removal processes for IGCC power plants

Simulation of CO2 capture from natural gas by cyclic pressure swing adsorption process using activated carbon

Application of Elevated Temperature Pressure Swing Adsorption in Hydrogen Production from Syngas

Simulation and Energy Consumption Comparison of Gas Purification System Based on Elevated Temperature Pressure Swing Adsorption in Ammonia Synthetic System

System And Processes Of Pre-Combustion Carbon Dioxide Capture And Separation

Steam-assisted Temperature Swing Adsorption for Carbon Capture Integrated with Heat Pump

Simulation and Optimization of Ion Transfer Membrane Air Separation Unit in an IGCC Power Plant

Optimization of Parameters and Thermodynamics of Gasification Process for Enhanced CO2 Capture in an IGCC System

Energy, Exergy, Economic and Environmental (4E) Analysis of an Integrated Process Combining CO2 Capture and Storage, an Organic Rankine Cycle and an Absorption Refrigeration Cycle

Study and demonstration of H2/CO2 separation of syngas from coal by elevated temperature pressure swing adsorption

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Simultaneously enhancing H2 recovery and CO2 captured pressure during the hydrogen purification process of medium-temperature shifting gas by coupled wet CO2 separation-PSA technology: From laboratory to industrial scale test