Abstract:Abstract Central cracking in cross-wedge-rolled workpieces results in high wastage and economic loss. Recent cross-wedge rolling tests on two batches of steel showed that one batch formed central cracks, while the other was crack-free. The batches were both nominally of the same chemical composition and thermomechanical treatment history. In addition, both batches had passed all the standard quality assessments set for conventional forging processes. It was suspected that the different cracking behaviours were due to differences in microstructure between the two as-received steel billets, and the material in cross-wedge rolling (CWR) was more sensitive to the initial microstructure compared with other forging processes due to its specific loading condition including ostensibly compression and large plastic strain. Nevertheless, no previous study of this important problem could be identified. The aim of this study is, therefore, to identify the key microstructural features determining the central crack formation behaviour in CWR. The hot workability of the as-received billets was studied under uniaxial tensile conditions using a Gleeble 3800 test machine. Scanning electron microscope with energy-dispersive X-ray spectroscopy and electron backscatter diffraction was applied to characterise, quantitatively analyse, and compare the chemical composition, phase, grain, and inclusions in these two billets, both at room temperature and also at the CWR temperature (1080 °C). Non-metallic inclusions (oxides, sulphides, and silicates) in the billets were determined to be the main cause of the reported central cracking problem. The ductility of the steels at both room and elevated temperatures deteriorated markedly in the presence of the large volumes of inclusions. Grain boundary embrittlement occurred at the CWR temperature due to the aggregation of inclusions along the grain boundaries. It is suggested that a standard on specifying the inclusion quantity and size in CWR billets be established to produce crack-free products.

Analysis and experimental studies of internal voids in multi-wedge cross wedge rolling stepped shaft

The Study of Central Cracking Mechanism and Criterion in Cross Wedge Rolling

Investigation and prediction of central cracking in cross wedge rolling

Influence of tool parameters on internal voids in cross wedge rolling of aluminum alloy parts

Influence of tool parameters on central deformation in two-wedge two-roll cross-wedge rolling

Finite Element Method Analysis of Micro Cross Wedge Rolling of Metals

Investigation on the inner hole spiral-groove of cross wedge rolling of hollow shafts with mandrel

Study on Forming Defects in the Rolling Process of Large Aluminum Alloy Ring Via Adaptive Controlled Simulation

Numerical Simulation and Experimental of Forming Defects in Roll-Bending Process for Z-Shaped Profiles With Large Cross-Section

Feasibility Analysis of Cross Wedge Rolling (CWR) of Hexahedral Billet

Experimental and numerical study on the micro-forming of copper multi-crystal

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Influence of Cooling Condition of Tools on Central Deformation of Workpiece and Tool Wear in Cross Wedge Rolling

A Multi-scale Modelling by Coupling Cellular Automata with Finite Element Method and Its Application on Cross-Wedge Rolling

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

Influences of Initial Porosity, Stress Triaxiality and Lode Parameter on Plastic Deformation and Ductile Fracture

Influence Analysis of Area Reduction for Necking in Twice-Stage Cross Wedge Rolling

Influence of tool parameters on tool wear in two-roll cross-wedge rolling

A novel method for ball forming by cross wedge rolling

Numerical and experimental analysis of defects control in cross wedge rolling for titanium alloy workpieces

Numerical and experimental research on warm cross wedge rolling of hollow shafts with corrugated surface