Abstract:AbstractMicro-scaled progressive sheet metal forming is a promising process for producing bulk microparts, given its advantages of high efficiency and low cost. To enhance forming quality and efficiency, it is important to have an in-depth understanding of the forming mechanism and model the forming process and fracture behavior accurately. However, the prediction of fracture formation in sheet materials at the micro-scale has not yet been well explored, and thus current knowledge is not sufficient to support the continued development and application of microforming technology. This study investigated progressive sheet forming of magnesium-lithium alloy sheets of different grain sizes to produce bulk microparts directly from sheet metal via shearing, extruding, piercing, and blanking. Using the Gurson–Tvergaard–Needleman (GTN) damage model, the effects of the size factor on the formation and evolution of voids were considered, and the shear-modified GTN model was established by combining Thomason’s and Lemaitre’s damage mechanics models. The modified model could predict not only the ductile fracture behavior dominated by tension under high-stress triaxiality at the micro-scale, but also the damage behavior controlled by shear deformation under low-stress triaxiality. The progressive forming process was simulated using the modified model, which was verified by experimentation and simulation. Comparisons of the experiments and simulations revealed the size effects on the forming defects and fracture behaviors of microparts during progressive sheet forming. The results show that the stress during deformation is mainly concentrated at the edge of microparts, and irregular geometric defects including burr, rollover, incline, and bulge become deteriorated with the increase of the initial grain size. This study enhances the understanding and prediction of ductile fracture in the micro-scaled progressive forming of sheet metals.

Numerical simulation of incremental sheet forming based on GTN damage model

DUCTILE DAMAGE ANALYSIS FOR FRACTURE IN SHEET METAL FORMING BASED ON GTN MESOSCOPIC DAMAGE MODEL

The GTN damage model based on Hill’48 anisotropic yield criterion and its application in sheet metal forming

Influence of GTN Meso-Damage Model Parameters on Sheet Forming Damage Behavior

Investigation of the Effect of Forming Parameters in Incremental Sheet Forming Using a Micromechanics Based Damage Model

A New Void Coalescence Mechanism During Incremental Sheet Forming: Ductile Fracture Modeling and Experimental Validation

Comparison of GTN Damage Models for Sheet Metal Forming

Extended GTN Model for Predicting Ductile Fracture under a Broad Range of Stress States

Modified Gtn Model for A Broad Range of Stress States and Application to Ductile Fracture

Anisotropic Gurson-Tvergaard-Needleman model considering the anisotropic void behaviors

The Numerical Method for Predicting Failure in Single Point Incremental Forming Using a New Anisotropic Ductile Fracture Model

GTN MESO-DAMAGE MODEL BASED ON DIFFERENT HARDENING RULES AND ITS APPLICATION FOR SPRINGBACK FINITE ELEMENT ANALYSIS IN SHEET METAL FORMING

Evaluation and simulation on deformation instability mechanism in laminated sheet incremental forming

Ductile fracture behavior in micro-scaled progressive forming of magnesium-lithium alloy sheet

Numerical prediction of ductile fracture in multi-stage single point incremental forming based on phenomenological modified Mohr–Coulomb

Extended Gurson-Tvergaard-Needleman model considering damage behaviors under reverse loading

Analytical Modeling of Fracture Strain and Experimental Validation in Incremental Sheet Forming

Parameter identification of a mechanical ductile damage using Artificial Neural Networks in sheet metal forming

Evaluation of the Forming Limit of Incremental Sheet Forming Based on Ductile Damage

Numerical analysis of medium-thick sheet metal semi-cutting process considering ductile damage

Analysis of Metallic Ductile Fracture by extended Gurson models