Abstract:Springback is one of the most important problems that should be compensated in sheet metal forming process with the increasing application of advanced high strength steels and light-weight alloys. In the finite element analyses for the springback, accurate modeling of Bauschinger effect, transient behavior and permanent softening under cyclic loading has been recognized as the most critical hardening behavior in the constitutive modeling aspect. However, if parts of these hardening behavior are not well modelled, is the accuracy of springback prediction seriously deteriorated? To answer this question, in this paper the significance of Bauschinger effect and transient behavior, permanent softening and unloading modulus in springback prediction were estimated using the springback problem of U-draw/bending simulations proposed at Numisheet2011 Benchmark. A recent anisotropic non-linear kinematic (ANK) model [Zang S, Guo C, Thuillier S, Lee M. A model of one-surface cyclic plasticity and its application to springback prediction. Int J Mech Sci 2011;53:425–35.] was adopted to estimate the significance of hardening behavior and unloading modulus because of its special feature. The ANK model can predict exactly the same monotonous stress–strain curves for different hardening schemes, while different Bauschinger effect and transient behavior under one-dimensional cyclic loading can be also modelled. This feature is quite suitable to quantitatively evaluate the effects of the aforementioned hardening behaviors in springback prediction. Initial anisotropy is described by the anisotropic yield function Yld2000-2d. The unloading behavior is also considered by defining Young's modulus as a function of equivalent plastic strain. Several quantitative analyses were carried out to distinguish the effect of each hardening component and unloading elastic modulus scheme. Finally, the predicted springback by different models were compared with experiments for both as-received and pre-strained DP780 steel sheets.

GTN MESO-DAMAGE MODEL BASED ON DIFFERENT HARDENING RULES AND ITS APPLICATION FOR SPRINGBACK FINITE ELEMENT ANALYSIS IN SHEET METAL FORMING

DUCTILE DAMAGE ANALYSIS FOR FRACTURE IN SHEET METAL FORMING BASED ON GTN MESOSCOPIC DAMAGE MODEL

The GTN damage model based on Hill’48 anisotropic yield criterion and its application in sheet metal forming

Modeling of metallic shear failure by void-based meso-damage model

Improvement of springback prediction accuracy applying a new constitute model considering damage and nonlinear elastic unloading-reloading behaviors

Influence of GTN Meso-Damage Model Parameters on Sheet Forming Damage Behavior

Comparison of GTN Damage Models for Sheet Metal Forming

Numerical simulation of incremental sheet forming based on GTN damage model

An application of fully coupled ductile damage model considering induced anisotropies on springback prediction of advanced high strength steel materials

On the numerical implementation of a shear modified GTN damage model and its application to small punch test

Influence of Ductile Damage on Springback Prediction of Aluminum Alloy Sheet under Changing Loading Paths

Mesoscopic Damage Mechanical Analysis for Uniaxial Tension of Automobile Galvanized Steel Sheet Specimens

Forming Limit Stress Diagram Prediction of Pure Titanium Sheet Based on GTN Model

Evaluating the Significance of Hardening Behavior and Unloading Modulus under Strain Reversal in Sheet Springback Prediction

A Combined Hardening Model for Multi-Stage Sheet Metal Forming

Parameter Calibration for a Shear Modified GTN Model and Its Application to Forming Limit Prediction

Springback Prediction of Magnesium Alloy Sheet with Nonlinear Combined Hardening

Extended GTN Model for Predicting Ductile Fracture under a Broad Range of Stress States

Investigation on the Influence of Damage to Springback of U-shape HSLA Steel Plates

Investigation of Mesoscopic Damage Evolution Mechanism of High Strength Steel in Hot Stamping Process

A Constitutive Model for Spring-Back Prediction in Which the Change of Young's Modulus with Plastic Deformation is Considered