Abstract:Surface microtexturing has been widely used due to its good hydrophobic or drag reduction characteristics, and become an effective method to improve product performance and reduce energy consumption. This paper mainly discusses the improvement of microtextures on the dynamic pressure characteristics of hydrostatic bearings, and explores the effects of texture parameters on carrying capacity, macroscopic wall two-plane shear force, cavity area and other factors. In the oil film model calculation of the smooth wall surface of the radial hydrostatic bearing under the action of high speed and large external load, the oil film divergent wedge often has a negative pressure area, which is obviously not in line with the actual situation, so the cavitation effect needs to be considered. The CFD analysis method of the "gas-oil" two-phase flow model was carried out by using the mixture model to seek the optimal texture model scheme and thus to improve the load carrying capacity (LCC) and reduce the wall shear force. The effects of the texture area arrangement and geometric parameters on the lubrication characteristics were compared and analyzed. It is found that the carrying capacity of local texture is better than that of global texture, and different texture arrangements can achieve better drag reduction rates. The work presented in this paper studies the lubrication of the surface texture of a hydrostatic bearing. Taking the oil film carrying capacity and shear force as the target parameters, the factors, such as texture morphology, geometric parameters, texture distribution and cavitation phenomenon, are investigated through simulation and experimental methods. The surface textured hydrostatic bearing is expected to obtain the maximum oil film carrying capacity and the minimum friction resistance. The analysis results show that by arranging the partial streamwise texture at the rear end of the diverging wedge, the maximum shear force of the wall can be reduced by about 15%, and the LCC can be increased by about 18%.

Parametric Design of Surface Textures on Journal Bearing

Effects of three types of surface texture on the performances of journal bearing

Experimental investigation for vibration reduction of surface-textured journal bearings

The Effect of Surface Textures on Loading Capacity of Journal Bearing Lubricating Film

Effect Of Large-Area Texture/Slip Surface On Journal Bearing Considering Cavitation

Optimal design of surface texture in meso scale air journal bearing

Effect of the Parameters of Surface Textures on the Hydrodynamic Lubrication Characteristics of Radial Bearing

Research on Load Carrying Properties of Surface Textured Journal Bearing

Modeling a Hydrodynamic Bearing with Provision for Misalignments and Textures

Effects of Texture Slip Surface on Load-Carrying Capacity and Cavitation of Bearing

An Analytical And Experimental Parametric Study of Texturing In Slider Bearings Under Hydrodynamic/Mixed Lubrication

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Effect of texture shapes and additives in lubricants on the dynamic characteristics of the hydrodynamic journal bearing

Hydrodynamic Lubrication of Partial Textured Sliding Journal Bearing Based on Three-Dimensional CFD

Optimization of surface texture distribution on the thrust bearing using the mass-conserving cavitation boundary condition: Theory and experiments

Drag Reduction Analysis of the Hydrostatic Bearing with Surface Micro Textures

Effects of Thermal and Elastic Deformations on Lubricating Properties of the Textured Journal Bearing

Study of grease lubricated journal bearing with partial surface texture

Effects of Surface Texture on Turbulent Lubrication of Water-lubricated Journal Bearing

Study of Acoustic Performance of Textured Journal Bearing

LOAD CARRYING CAPACITY OF PARTIALLY TEXTURED SLIDING JOURNAL BEARING BASED ON THREE DIMENSIONAL CFD