Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

Tribological performance of a surface textured meso scale air bearing

Optimal design of surface texture in meso scale air journal bearing

Effect of texture shapes and additives in lubricants on the dynamic characteristics of the hydrodynamic journal bearing

Effect of Micro-Dimple Geometry on the Tribological Characteristics of Textured Surfaces

Experimental investigation for vibration reduction of surface-textured journal bearings

An experimental analysis of the hydrodynamic contribution of textured thrust bearings during steady-state operation: A comparison with the untextured parallel surface configuration

Study of grease lubricated journal bearing with partial surface texture

Friction and wear properties of textured surface for bearing steel with mango-shaped micro geometries

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Research on tribological performance of textured thrust bearing using gray relational degree and improved multi-objective water circulation algorithm

Simulation and Experimental Study on Tribological Properties of Herringbone Texture on 42CrMo Bearing Alloy Steel Surface

Effect of surface texture on the frictional properties of grease lubricated spherical plain bearings under reciprocating swing conditions

Research Progress on the Design of Surface Texture in Tribological Applications: A Mini-Review

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Influence of micro-texture radial depth variations on the tribological and vibration characteristics of rolling bearings under starved lubrication

Numerical and experimental investigation of textured journal bearings for friction reduction

Effect of surface square textures on the physical field of static and dynamic pressure thrust bearings and multi-objective optimization

Performance evaluation of different types of micro-textured hydrostatic spindles under the main influencing factors

Tribological roles of MoS2 and PTFE nano oils at the rolling/sliding point contacts: Conventional versus textured contacts

Texture Optimization and Verification for the Thrust Bearing Used in Rotary Compressors Based on a Transient Tribo-Dynamics Model

Surface Tribological Properties Enhancement Using Multivariate Linear Regression Optimization of Surface Micro-Texture