Abstract:Surface texturing has been shown to reduce friction and improve durability in mechanical face seals and metal forming operations, and lightly loaded thrust bearings. However, the success has been limited to conformal contacts and low load high speed operating conditions, i.e. hydrodynamic lubrication dominated regime. Both experiments and numerical simulations have shown that textural patterns, under higher loading and/or slower speeds may increase friction and even cause the lubrication film collapse. Specific designs of surface texture pattern, as its shape, depth and density, are required for different lubrication regimes. Our own study has shown (Hsu et al 2014 J. Phys. D: Appl. Phys. 47 335307) that large/shallow dimple reduces friction in hydrodynamic lubrication regime, whereas small/deep dimple shows benefit in mixed/boundary lubrication regimes (if the textural designs can provides hydrodynamic/hydrostatic lift forces to reduce the machine loading). In considering an engine component typically experiences duty cycles that may cross various lubrication regimes, a multiscale surface texture design appears attractive. This type of mixed shape texturing combines textures designed for low load, high speed operating conditions and the textures that are designed for high load, low speed operations. In this paper, two types of multiscale surface texture designs are presented. Ball-on-three-flats (BOTF) wear tester (under high loading conditions) is used to evaluate the performance of these multiscale texture designs along with the baselines of un-textured surfaces under the same surface preparation procedures. Two texture designs with only a single shape dimples are included in the study. Results suggest that multiscale surface texture design not only further reduces friction in comparison to the textures with single shape dimples, but also shows the effectiveness across hydrodynamic regimes to the mixed lubrication regimes.

Optimal Design of Surface Texture in Parallel Thrust Bearings

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Numerical Optimization of the Groove Texture Bottom Profile for Thrust Bearings

Optimization of surface texture distribution on the thrust bearing using the mass-conserving cavitation boundary condition: Theory and experiments

Optimal design of surface texture in meso scale air journal bearing

Numerical analysis of lubrication properties on a bio-inspired parabolic textured surface

Optimization of Groove Texture Profile to Improve Hydrodynamic Lubrication Performance: Theory and Experiments

Research on Internal Flow Field Characteristics of Straight-Groove Texture Using Three-Dimensional Modeling

Design and Optimization of the Surface Texture at the Hydrostatic Bearing and the Spindle for High Precision Machining

Effect of surface square textures on the physical field of static and dynamic pressure thrust bearings and multi-objective optimization

Performance analysis of columnar convex-concave compound microtexture thrust bearing

Texture Optimization and Verification for the Thrust Bearing Used in Rotary Compressors Based on a Transient Tribo-Dynamics Model

Influence of surface texture on pocket pairs lubrication performance of cylindrical roller bearings

Design of groove structures for bearing lubrication enhancement based on the flow mechanism analysis

Study of grease lubricated journal bearing with partial surface texture

An experimental analysis of the hydrodynamic contribution of textured thrust bearings during steady-state operation: A comparison with the untextured parallel surface configuration

Self-adaptive surface texture design for friction reduction across the lubrication regimes

Research on tribological performance of textured thrust bearing using gray relational degree and improved multi-objective water circulation algorithm

A Design of Partial Textured Surface on Gear Washers for Reducing Friction and Wear under Low Speed and Heavy Load Conditions

Coupled Optimization of Groove Texture for Parallel Ring–Ring Friction Pairs: Theory and Experiments

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer