Abstract:Superfine silver powders are building blocks of silver paste, which plays a vital role as a conductive material in solar cells. The conductivity of silver paste is greatly affected by the shape, size, and homogeneity of silver powders. In this paper, superfine spherical silver powders with good sphericity and smooth surfaces were prepared by using the non-wetting effect of the liquid/solid interface. Hexagonal boron nitride and magnesium oxide were chosen as dispersants for the preparation of the silver powders. Hexagonal boron nitride with low surface energy was beneficial for the sphericity of the silver powders, and magnesium oxide with high density and hardness was beneficial for their size distribution. The result of scanning electron microscope (SEM) images showed the powders prepared via the non-wetting effect of the liquid/solid interface exhibited better sphericity and smoother surfaces than powders prepared by the liquid phase chemical reduction method, which is by far the most commonly used method. The size distribution of silver powders using magnesium oxide as dispersant was 0.2—2.4 µ m, which meets the requirements of solar cells. After sintering at 500°C, the sheet resistance of the silver film was as low as 12.71 mΩ/sq, implying good electrical conductivity.

Mono-disperse spherical Cu–Zn powder fabricated via the low wettability of liquid/solid interface

In-situ De-Wetting Assisted Fabrication of Spherical Cu-Sn Alloy Powder Via the Reduction of Mixture Metallic Oxides

The Formation of Ultrafine Spherical Metal Powders Using a Low Wettability Strategy of Solid–liquid Interface

A Novel Synthetic Strategy of Fe@Cu Core-Shell Microsphere Particles by Integration of Solid-State Immiscible Metal System and Low Wettability

In Situ De-Wetting of Liquid–solid Interface to Fabricate Spherical Ag@Ni Immiscible Alloys

A Novel Fabrication of Spherical Fe50Ni50 Alloy Powders Via In-Situ De-Wetting of Liquid Solid Interface

Fabrication of Spherical Fe-based Magnetic Powders Via the in Situ De-Wetting of the Liquid–solid Interface

Fabrication of spherical W–ZrC powder for additive manufacturing by spray granulation combined with plasma spheroidization

Production of Spherical TiAl Alloy Powder by Copper-Assisted Spheroidization

Synthesis of Hierarchical CuS Flower-Like Submicrospheres Via an Ionic Liquid-Assisted Route

Fabrication of Cu Particles with Porous Surface and Enhanced Sinter-Bondability between Cu Finishes by Physically In Situ Formation of Cu Nanoparticles Using Them

Controllable Synthesis of Well-Monodispersed ZnS Nanospheres Through a Simple Sol–Gel Method and a Rapid Co-Phase Precipitation Method

Low-Temperature Synthesis of Nearly Monodisperse ZnS Nanospheres Using a Facile Solution-Phase Approach

Preparation and Characterization of Mono-disperse Spherical Nickel Particles

Synthesis and Characterization of Silver-Coated Copper Powder Layer

The role of the liquid-liquid interface in the synthesis of nonequilibrium crystalline wurtzite ZnS at room temperature

Charge Shielding-Oriented Design of Zinc-Based Nanoparticle Liquids for Controlled Nanofabrication.

Preparation of spherical ultrafine zirconia powder in microemulsion system and its dispersibility

Atomization of the Fe-rich MnNiCoCr high-entropy alloy for spherical powder production

A novel wet-chemical method of preparing highly monodispersed Cu2O nanoparticles

Preparation of Superfine Spherical Silver Powders for Solar Cell Silver Paste Via Non-wetting Effect of the Liquid/Solid Interface