Abstract:The objective of this paper is to determine how the high-voltage discharging metal vapour deposited on the nearby ceramic inner surface influences the breakdowns of gaps between centre shield and end shield in vacuum interrupters. Two types of shield materials were selected, namely copper and stainless steel. The end curvature radius of the shield was 3 mm. The distance between the shields could adjust manually from 4 to 8 mm. The distance between the shields and ceramic was 3.5 mm. The negative polarity standard lightning impulse voltage (12/50 μs) was repeated for 900 operations based on an up-and-down method. The experimental results illustrated that the metal deposition layer on the inner surface of the ceramic envelope significantly influenced the breakdown voltage of the shield gaps. At a shield gap distance of d = 4 mm, the breakdown voltage of the shield gap increased from an initial lower voltage to the saturation voltage by approximately 200 operations. Then, the breakdown voltage decreased to a lower voltage range during only 50 operations, and the breakdown voltage maintained at this lower voltage range until the end of 900 operations. Furthermore, as the shield gap distance increased from d = 4 to 6 mm and 8 mm, the breakdown voltage also maintained at this lower voltage range. A metal deposition layer was formed on the inner surface of ceramic by repetitive application of the lightning impulse voltage. To analyse the influence of the metal deposition layer, the electric field distributions were calculated for the original vacuum interrupter and the vacuum interrupter with the metal deposition layer on the ceramic inner surface. The simulation results suggested that the metal deposition layer took part in the breakdown path between the shield gaps and deteriorated the insulation performance.

Insulation performance of vacuum interrupter after high frequency voltage impulses conditioning

Research on AC and High Frequency Breakdown Characteristics of Oil-paper Insulation of 220 Kv Current Transformers

Transient characteristics and sites of pre‐breakdown in spark conditioning for high‐voltage vacuum interrupter under power frequency voltage

Improvement of AC Conditioning Effect in Vacuum by High Frequency Voltage

On the Relationship Between Internal Pressure and Permittivity in the Interrupter of VCB

Experimental Study and Analysis of Insulator Breakdown Characteristics with Short-tail Lightning Impulse

Vacuum electrical breakdown conditioning study in a parallel plate electrode pulsed DC system

An electro-optical measurement on electric field of insulator surface under HV pulse in vacuum

Experimental investigation the impact of electric discharge on ice accretion

Experimental Researches on Lightning Impulse Corona Characteristics of Conductors

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Influence of switching operations on the vacuum interrupter dielectric strength

A New Measurement Method of Contact Conditions in a Vacuum Circuit Breaker With the Field Emission Current During the Closing Operation

Flashover Performance of Pre-contaminated and Ice-covered Composite Insulators to be Used in 1000 kV UHV AC Transmission Lines

Utilizing Ratio Frequency signal in online monitoring on high voltage vacuum cubicle switchboard

Restoring over-voltage protection equipment for power frequency insulation experiments

Optical Diagnostics of Vacuum Arc in the process of DC Interruption

Vacuum Surface Flashover Induced by Load Current in Pulsed Power Facilities

Partial Discharge Characteristics of Uniform Gap in Oil-Impregnated Paper Insulation under Switching Impulse Voltage

Lightning Impulse Flashover Characteristics of Glass Insulator String with RTV Coating

Breakdown of shield gaps in vacuum interrupters