Abstract:The high-voltage performance of insulator is one of the main areas of pulsed power research and development, and the surface flashover voltage is the critical factor strongly influencing the voltage hold-off capability of vacuum pulsed power devices. In this work, the influence of different electrodes and boundary conditions on the electric field distribution at the triple junction was simulated and experimentally studied. The results indicate the value of V-ho can be raised significantly as the screening length increased from 3mm to 18mm, the hold-off voltage of the screening electrode is up to 150 kV and over 50% higher than that of the plate electrode. However, the hold-off voltage decrease after the screening electrode becomes longer than 18 mm The reason for the observed wide dispersion in the breakdown values for the different electrodes was explored by examining surface structures of the insulator under an SEM (Scanning Electron Micrograph). When the value of screening length is greater than 18mm, we could find breakdown point in special area. For the better explanation of the experiment phenomenon, a simulation model of the surface flashover in vacuum with special configuration is established by a 2D PIC-DSMC code, in which some basic physical process such as field emission in the vicinity of the metal-vacuum-dielectric junction, charge accumulation effect in insulator surface, secondary electron emission, gas desorption, and electrons interact with gas etc are considered. These simulation results are in comparison with the experiment phenomenon, these are the base to in-depth understand surface flashover in vacuum. A new developing process of surface flashover in vacuum by high voltage pulses is also discussed.

An electro-optical measurement on electric field of insulator surface under HV pulse in vacuum

Online Measurement of Pulsed Electric Field of Insulator Surface in Vacuum Based on Kerr Effect

On-line measurement on surface electric field of insulator in vacuum based on Kerr effect

System for On-line Measuring Electric Field on Insulator Surface Based on Kerr Effect

Measurement of surface charge distribution on insulating material under pulsed voltage

Spectrum measurement of surface flashover under high voltage nanosecond pulse

Process of Surface Flashover in Vacuum Under Nanosecond Pulse

Influence of Flashover Initiation Process on Surface Insulation Performance for Insulators under Impulse Voltage in Vacuum

Surface Electric Field Analysis of Insulating Material with Transitional Permittivity in Vacuum

Measurements of Electric Field and Charge on Insulator Surface

Surface Flashover of Alumina Ceramic Insulators in Vacuum

Investigation On Novel Parameter Characterizing Surface Flashover Phenomena In Vacuum

Method of Measuring Field Emission Current under High-Voltage Pulse

Vacuum Surface Flashover Induced by Load Current in Pulsed Power Facilities

Comparison of surface charge distributions under vacuum and atmospheric condition due to surface discharge events

Improvement of Surface Flashover in Vacuum

Distortion of the Electric Field Near Insulator Surface Observed with Electro-Optical Technique Measuring Kerr Effect

Surface Charge Characteristics on Insulators in Vacuum under Nanosecond Pulse Excitation

Optical Investigation of Surface Flashover Plasma Across Silicon Stimulated by Pulsed High Voltage in Vacuum Based on Iccd

Surface Flashover Characteristics of Polyethylene Film under Ns Impulse Voltage in Vacuum

Research Progress on Surface Flashover Phenomena Across Solid Insulation in Vacuum