Abstract:As wind turbines become larger and move into deeper sea, their operating environment is getting more and more harsh, which puts higher stability requirements of the transmission chain. The mechanical-hydraulic hybrid transmission (MHHT) combines mechanical and hydraulic systems to improve transmission stability. However, the related research is still in the stage of mechanism verification. In this paper, a 19-degree-of-freedom pure torsion model has been established to study the internal characteristics of the MHHT chain. The model contains parallel gearing, planetary gearing and closed hydraulic transmission simultaneously. The correctness of the modelling method was verified by a software model. The frequency characteristics of the hybrid transmission chain were summarized. The first two modes at different motor displacements were classified as “mechanical mode” and “hydraulic mode” based on the mode shapes. A hydraulic damping model was built based on the leakage of the hydraulic system. The influence of the hydraulic system on the MHHT damping characteristics has been discussed in detail with and without considering the mechanical damping. Finally, a damping compensation method by adjusting the hydraulic motor displacement was proposed. The control algorithm was derived by a simplified model and verified by the 19-degree-of-freedom pure torsion model. The simulation results under different working conditions show that this method can effectively reduce the first-mode torsional vibration and improve the life of the drivetrain.

Modeling and Analysis of Torsional Vibration on Engine-generator System of Hybrid Electric Vehicle

A General Approach to Tune the Vibration Properties of the Mounting System in the High-Speed and Heavy-Duty Engine

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Torsional Vibration of a Shafting System under Electrical Disturbances

Signal Analysis on Flexural and Torsional Vibration of Generator Shafts Impacted by Subsynchronous Resonance

Research on Transmission Characteristics and Torsional Vibration Control of Hybrid Transmission Wind Turbines

Modeling and active control of power-split hybrid electric vehicle launch vibration

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

A novel two degree-of-freedom dynamic model of a full hybrid vehicle

Dynamic optimization of tracked vehicle power train based on torsional vibration analysis

A Simplified 4-DOF Dynamic Model of a Series-Parallel Hybrid Electric Vehicle

MODELING AND CALCULATION OF THE NATURAL FREQUENCY OF 300 MW URBO-GENERATOR ROTOR SHAFT SYSTEM

Noise and Torsional Vibration Analysis of Hybrid Vehicles

Analysis of Speed-Dependent Vibration Amplification in a Nonlinear Driveline System Using Hilbert Transform

Dynamic Analysis and Study on Shaft's Torsional Vibration of Electrical Traction Shearer's Motor-Rocker and Deceleration System

Vibration and dynamics analysis of electric vehicle drivetrains

Analysis of electromechanical coupling characteristics of electrics vehicle electric drive system considering current harmonic excitation

Investigation of simulation experiment on active control of torsional vibration in a turbogenerator shaft system

Research on coupled vibrations of driveshaft–rear axle system based on nonlinear hybrid model

Abuse Torque Load Simulation and Design of Differential Mechanism in Hybrid Electric Vehicle

Analysis and experiment on abnormal vibration for power assembly of diesel engine