Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

Modeling and active control of power-split hybrid electric vehicle launch vibration

A disturbance-observer-based feedforward-feedback control strategy for driveline launch oscillation of hybrid electric vehicles considering nonlinear backlash

An active multiobjective real-time vibration control algorithm for parallel hybrid electric vehicle

A Simplified 4-DOF Dynamic Model of a Series-Parallel Hybrid Electric Vehicle

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Research on Transmission Characteristics and Torsional Vibration Control of Hybrid Transmission Wind Turbines

Active Vibration Control Strategy for Online Application in a Range Extender

Multi-objective optimization of active suspension system in electric vehicle with In-Wheel-Motor against the negative electromechanical coupling effects

Research on the Anti-Shuffle Control for Hybrid Electric Vehicles in the Pure Electric Mode

A novel two degree-of-freedom dynamic model of a full hybrid vehicle

Robust Preview Control for Half‐Vehicle Active Suspension System of Hub‐Driven Electric Vehicles with Coupling Effects

Step-control and Vibration Characteristics of a Hybrid Vehicle Suspension System Considering Energy Consumption

Research on the Energy Control of a Dual-Motor Hybrid Vehicle During Engine Start-Stop Process

An experimental investigation of resonance sources and vibration transmission for a pure electric bus

Robust Development of Electric Powertrain NVH for Compact Electric SUV

Robust Vibration Control for Active Suspension System of In-Wheel-Motor-Driven Electric Vehicle via μ-Synthesis Methodology

Electromechanical coupling dynamic characteristics of electric drive system for electric vehicle

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

Analysis and Control of Engine Starting Process Based on a Novel Single-Motor Power-Reflux Hybrid Electric Vehicle

Vibration and dynamics analysis of electric vehicle drivetrains

Traction Control Method of Hybrid Electric Vehicle based on Multi-Objective Dynamic Coordination Control