Abstract:Two kinds of C/C composites with rough-lamination pyrocarbon matrix (RL) or smooth lamination (SL) pyrocarbon matrix were prepared. The sliding friction behaviors against 40Cr steel ring of the two C/C composites, a high strength graphite and a pyrocarbon solid material with SL structure used as compared material were investigated. The wear surface of the samples were observed by SEM. The results show that the PAN-carbon fiber can improve the frictional stability of C/C composites. Compared with the graphite, the coefficients of friction (COF) of the RL-C/C are lower under the same load of about 0.08?0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02?0.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

Sliding Friction and Wear Behavior of C/C Composites Against 40 Cr Steel

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Sliding Friction and Wear Behavior of C/C Composite Ring Against C/C Composite Block

Friction and Wear Behavior of Carbon Material and C/C Composites with Similar Structure

Influence of Load on Sliding Tribology of C/C Composite with 40cr Steel Couple Coated by Cr

To-fro sliding tribological behavior of C/C composite under different loads

Sliding Friction Behavior of C/C Composites with Water Lubrication Using 40Cr Coated by Cr Ring

Characteristics of Wear Surface Morphology and Wear Mechanism of C/C Composite with Different Matrix Carbon

Influence of Carbon Matrix on the Tribology of C/C Composites Used As Shaft Sealing Ring

SEM, AFM and LFM Study of the Worn Surface of C/C Composites with Smooth Lamination and Rough Lamination/Resin Carbon Matrixes

Influence of PAN-fiber Flat Weaved form on the Sliding Tribological Behavior of C/C Composites

Friction and Wear Behaviors of B4c/6061al Composite

Friction and Wear Properties of Carbon/carbon Composites with Different Martix Carbon

INFLUENCE OF THE DENSITY ON THE SLIDING TRIBOLOGY BEHAVIOR OF C/C COMPOSITE WITH 40cr STEEL COATED BY Cr COUPLE

Sliding Friction Wear Behaviors of C/C Composites Coupled with GH4169 Alloy and High-Strength Graphite

The Effect of C/C Composites Characteristic on Sliding Friction and Wear Behavior

Friction and wear properties of C/C-Cu composites sliding at various velocities

Influence of Fiber Orientation on Sliding Tribology Behavior of C/C Composite

New Insights into the Microstructure of the Friction Surface Layer of C/C Composites

Friction and wear properties of short carbon fiber reinforced aluminum matrix composites

Friction and wear behavior of three-dimensional braided carbon fiber/epoxy composites under dry sliding conditions