Abstract:Friction and wear experiments were performed on carbon fiber-reinforced polymer (CFRP) composites, and the tribological behavior of these materials under boundary lubrication (based on the 5100 4T 10 W-30 engine oil with TiO2 Degussa P25 nanoparticles) was investigated. Experiments were carried out in two directions: one at a different normal load from 6 to 16 N and one at a low sliding speed of 110 mm/min under boundary lubrication conditions. The obtained results reveal the stick-slip effect and the static and dynamic coefficient of friction decreased slightly with increasing normal applied load on the carbon fiber reinforced polymer composite pairs. The second direction highlights through experimental tests on the pin on disc tribometer that the friction coefficient increases with the increase in normal load (20–80 N) and sliding velocity (0.4–2.4 m/s). On the other hand, it is found that the friction coefficient is slightly lower than in the stick-slip phase. During the running-in process, the friction coefficient of the CFRP pair increases steadily as the rubbing time increases, and after a certain rubbing period, it remains constant regardless of the material of the counter face. The obtained results show that for the observed interval, the influence of normal load and sliding velocity have relatively small fraction coefficients and low wear depths. A 3D analysis of the profile demonstrated the texture of wear marks and tracks of these engineering composite materials. Furthermore, the height variations of wear marks and the morphologies of the worn surfaces of specimens under boundary lubrication conditions were analyzed.

To-fro sliding tribological behavior of C/C composite under different loads

Influence of Load on Sliding Tribology of C/C Composite with 40cr Steel Couple Coated by Cr

Sliding Friction and Wear Behavior of C/C Composites Against 40 Cr Steel

A Comparative Investigation of the Tribological Behavior and Wear Mechanism of Bronze-graphite Composite under Dry- and Water-lubricated Sliding Against Steel

Sliding Friction and Wear Behavior of C/C Composite Ring Against C/C Composite Block

Friction and Wear Behavior of Carbon Material and C/C Composites with Similar Structure

Influence of PAN-fiber Flat Weaved form on the Sliding Tribological Behavior of C/C Composites

INFLUENCE OF THE DENSITY ON THE SLIDING TRIBOLOGY BEHAVIOR OF C/C COMPOSITE WITH 40cr STEEL COATED BY Cr COUPLE

Sliding Friction Behavior of C/C Composites with Water Lubrication Using 40Cr Coated by Cr Ring

Influence of Fiber Orientation on Sliding Tribology Behavior of C/C Composite

Sliding Friction Wear Behaviors of C/C Composites Coupled with GH4169 Alloy and High-Strength Graphite

Reciprocating Frictional Properties of C/C Composite under Different Frequencies

Influence of Carbon Matrix on the Tribology of C/C Composites Used As Shaft Sealing Ring

Characteristics of Wear Surface Morphology and Wear Mechanism of C/C Composite with Different Matrix Carbon

TRIBOLOGY PROPERTIES OF C/C COMPOSITES AND GRAPHITE AT NON-LUBRICATION WEAR ENVIRONMENT

SEM, AFM and LFM Study of the Worn Surface of C/C Composites with Smooth Lamination and Rough Lamination/Resin Carbon Matrixes

Friction and Wear Behaviors of B4c/6061al Composite

Friction and Wear Properties of Carbon/carbon Composites with Different Martix Carbon

The Effect of C/C Composites Characteristic on Sliding Friction and Wear Behavior

Experimental Investigation of the Tribological Behaviors of Carbon Fiber Reinforced Polymer Composites under Boundary Lubrication

Friction and wear properties of short carbon fiber reinforced aluminum matrix composites