Abstract:In order to offer higher average brightness and more stable photon beam, top-up injection mode is scheduled for daily operation in SSRF. Several critical beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely and reliably, and few interlock logics need to be added into machine protection system with top-up mode. Several hardware and software optimizations of beam instrumentation for this purpose will be introduced in this paper. OVERVIEW Shanghai Synchrotron Radiation Facility (SSRF) is a third generation light source, which located at Shanghai, P.R. China. Since December 2012, SSRF has operated in top-up mode for user experiments, which was a milestone of SSRF in facility performance improvements. The topup injections are made continuously at the time interval of about 10 minutes. Each injection cycle takes about 10 seconds and the bunch change uniformity of the 500 bunch train is better than 95%. For the top-up operation, several beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely. Some extra interlock logics were added into machine protection system. This paper will introduce the details of hardware and software optimizations of beam instrumentation for the purpose above. FILLING PATTERN Bunch charge uniformity control is very important for the top-up operation. The quality mainly depends on the precision of bunch charge & filling pattern measurement. This measurement can be realized by direct sampling BPM pickup signal [1-3] or synchrotron radiation signal [4]. Due to easy configuration and good linearity button, BPM pickups and PXI waveform digitizer based solution have been adopted [5].

Injection Performance Evaluation for Ssrf Storage Ring

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Beam instrumentation system development and commissioning in ssrf

Research of bunch by bunch data acquisition system in SSRF

Monitoring the Charge Bunch-by-bunch for the SSRF Storage Ring： Development and Application

Experimental Study Using Touschek Lifetime As Machine Status Flag in SSRF

Bunch-by-Bunch Study of the Transient State of Injection at the SSRF

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

New Noninvasive Measurement Method of Optics Parameters in a Storage Ring Using Bunch-by-bunch 3D Beam Position Measurement Data

Upgrade of Bunch Phase Monitor at SSRF Storage Ring

Bunch-by-bunch Three-Dimensional Position and Charge Measurement in a Storage Ring

Bunch-by-bunch Beam Size Measurement During Injection at Shanghai Synchrotron Radiation Facility

Bunch-by-bunch phase study of the transient state during injection

Ssrf beam diagnostics system commissioning

Ssrf injector diagnostics commissioning results

Beam Position Monitor System for SSRF Storage Ring

Design and Testing of a Bunch-by-bunch Beam Position Transverse Feedback Processor

Development of Button-Type Pickup for SSRF Ring

Longitudinal acceptance measurement at an electron storage ring

Bunch-by-bunch Beam Transverse Feedback Electronics Designed for SSRF

The Magnet Design of the Ssrf Storage Ring and Booster