Abstract:In order to offer higher average brightness and more stable photon beam, top-up injection mode is scheduled for daily operation in SSRF. Several critical beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely and reliably, and few interlock logics need to be added into machine protection system with top-up mode. Several hardware and software optimizations of beam instrumentation for this purpose will be introduced in this paper. OVERVIEW Shanghai Synchrotron Radiation Facility (SSRF) is a third generation light source, which located at Shanghai, P.R. China. Since December 2012, SSRF has operated in top-up mode for user experiments, which was a milestone of SSRF in facility performance improvements. The topup injections are made continuously at the time interval of about 10 minutes. Each injection cycle takes about 10 seconds and the bunch change uniformity of the 500 bunch train is better than 95%. For the top-up operation, several beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely. Some extra interlock logics were added into machine protection system. This paper will introduce the details of hardware and software optimizations of beam instrumentation for the purpose above. FILLING PATTERN Bunch charge uniformity control is very important for the top-up operation. The quality mainly depends on the precision of bunch charge & filling pattern measurement. This measurement can be realized by direct sampling BPM pickup signal [1-3] or synchrotron radiation signal [4]. Due to easy configuration and good linearity button, BPM pickups and PXI waveform digitizer based solution have been adopted [5].

Monitoring the Charge Bunch-by-bunch for the SSRF Storage Ring： Development and Application

Research of bunch by bunch data acquisition system in SSRF

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Digital Bunch-By-Bunch Transverse Feedback System at Ssrf

The Application of FPGA-based DSP Module in SSRF Storage Ring

LOW Q CAVITY BPM STUDY FOR THE BEAM POSITION MEASUREMENT OF NANOSECOND SPACED ELECTRON BUNCHES *

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

Beam instrumentation system development and commissioning in ssrf

Development of fiber beam loss monitor based on Cerenkov principle

Hefei light source storage ring bunch by bunch 3D position measuring system is introduced and a preliminary study is shown

High-resolution Cavity Bunch Arrival-Time Monitor for Charges Less Than 1 Pc

Conditioning of BPM pickup signals for operations of the Duke storage ring with a wide range of single-bunch current

Bunch-by-bunch Beam Transverse Feedback Electronics Designed for SSRF

Bunch Charge Monitoring System Based on Integrating Current Transformer

One In-Situ Extraction Algorithm for Monitoring Bunch-by-Bunch Profile in the Storage Ring

The bunch current measurement using high-speed photodetector at HLS II

Temporal Profile Monitor Based on Electro-Optic Spatial Decoding for Low-Energy Bunches

Generation and Measurement of Velocity Bunched Ultrashort Bunch of Pc Charge

Quantitative Analysis of the High Speed and High Precision Waveform Digital System for Jinping Neutrino Experiment

Study of Algorithms of Phase Advance Measurement Between BPMs and Its Application in SSRF

Design and application of beam loss monitoring system for SSRF storage ring