Abstract:Aerobreakup of fluid droplets under the influence of impulsively generated high-speed gas flow using an open-ended shock tube is studied using experiments and numerical simulations. Breakup of mm-sized droplets at high Weber number was analyzed for water and two-phase nanofluids consisting of dispersions of Al2O3 and TiO2 nanoparticles in water with high loading of 20 and 40 weight % respectively. Droplet breakup is visualized using high-speed imaging in the experimental setup, where an open ended shock tube generates impulsive high-speed flow impinging on a droplet held stationary using an acoustic levitator. Axisymmetric simulations using the Volume of Fluid technique are conducted to capture the gas dynamics of the flowfield and droplet deformation at the initial stages. Fluid droplets are subject to a transient flow field generated by the open ended shock tube, characterized by a propagating incident shock wave, a recirculating vortex ring, and standing shock cells. Droplet breakup for all fluids proceeds through an initial flattening of the droplet followed by generation of a liquid sheet at the periphery in the presence of a curved, detached shock front at the leading edge. The breakup appears to follow a sheet stripping process whereby stretched ligaments undergo secondary atomization through viscous shear. Mist generated in the wake of the droplet appears to expand laterally due to the unconstrained expansion of the high-speed gas jet. The breakup morphology of droplets for all fluids appears consistent with previous observations using conventional shock tubes. Lateral deformation of the coherent droplet mass is observed to be higher for nanofluids as compared to water. This is attributed to higher viscosity and Ohnesorge number of nanofluid droplets, which results in delayed breakup and increased lateral stretching.

ICONE11-36029 DROPLET BREAKUP UNDER IMPULSIVE ACCELERATION USING MOVING PARTICLE SEMI-IMPLICIT METHOD

Two-dimensional Simulation of Drop Deformation and Breakup at Around the Critical Weber Number

Numerical Simulation of the Collision Behaviors of Binary Unequal-Sized Droplets at High Weber Number

Direct simulation of interfacial flows for multi-phase and multi-component mixtures using the particle method

Numerical Simulation of Liquid Droplet Breakup in Supersonic Flows

Modeling the Wetting Effects in Droplet Impingement Using Particle Method

Numerical Simulation of a Single Drop Impact on Liquid Surface using Particle Method

Two-dimensional numerical simulation of hydrodynamic behaviors of drop covered with vapor film

Experimental Study on Droplet Breakup in an Orifice Jet Mixer

Direct Numerical Simulation of Droplet Breakup in Homogeneous Isotropic Turbulence: the Effect of the Weber Number

Single and two-phase fluid droplet breakup in impulsively generated high-speed flow

On the Threshold of Drop Fragmentation under Impulsive Acceleration

Numerical Simulation of Droplet Oblique Impact on Liquid Film with Moving Particle Semi-Implicit Method

Numerical simulation of the aerobreakup of a water droplet

Numerical Study of Droplet Fragmentation During Impact on Mesh Screens

Simulation of dynamic characteristics of droplet impact on liquid film

Detailed numerical investigation of the drop aerobreakup in the bag breakup regime

Droplet breakup and coalescence of an internal-mixing twin-fluid spray

Droplet breakup and rebound during impact on small cylindrical superhydrophobic targets

A consistent volume-of-fluid approach for direct numerical simulation of the aerodynamic breakup of a vaporizing drop

Simulation and modeling of the vaporization of a freely moving and deforming drop at low to moderate Weber numbers